Table of Contents
Advertisement
FIGURE 14
TOP
COVER
A
YOUR SPRING LOADED MOWER DEFLEC¬
TOR SHIELD (FIG. 141 MUST NOT BE
REMOVED SIMPLY ROTATE IT UP AND
HOLD IN UP POSITION WHILE AT¬
TACHING CHUTE EXTENSION. THE
MOWER DEFLECTOR SHIELD CAN BE
RELEASED TO REST AGAINST CHUTE EX¬
TENSION. THIS WILL ASSURE DEFLEC¬
TOR SHIELD IS STILL ON MOWER IF
CHUTE EXTENSION OF GRASS CATCHER
ATTACHMENT IS REMOVED-
FIGURE 15
ELBOW
SHIELD
1 3 Assemble chute extension to mower housing.
a
Remove cardboard insert from rectangular
opening.
b Insert chute extension pin into latch assembly
spacer (Fig. 14 - R.H. Inset).
c, Lift up slightly on L.H. side of chute extension
lining up spacers located on latch assembly and
chute extension (Fig 14 - Lower Inset).
d. Secure R.H. side of chute extension to latch
assembly using: retainer spring (shown full size
below) (Fig. 14 - R.H Inset) Chute extension
and retainer spring furnished with grass
' catcher.
14
Advertisement
Table of Contents
