Samsung NSG6DG8100SR Manual page 36

Maintenance
NOTE
• After cleaning, confirm that the burner port openings aren't plugged.
• Shake out any excess water and then let burner heads and caps dry thoroughly.
Placing the center burner upside down will allow the water to drain out more easily.
• Do not wash any burner components in a dish washer.
CAUTION
• The starter electrodes are not removable. Do not attempt to remove them by force.
• To avoid chipping, do not bang grates and caps against each other or against
hard surfaces, such as cast iron cookware.
• The burner head can be blocked by food or dust. Clean the head if it appears
blocked. If you clean the head with water, assemble it only after it is completely
dry. If the head is wet, it might prevent the burners from igniting.
• To avoid falling down the grates, make sure to remove both sides grates first.
• Do not attempt to remove center oval burner cap from the head.
Burner reinstall guide
36 English
Round burner head
1. Orient the burner head so that the
opening for the electrode lines up with
the electrode.
2. Install the burner head so that the
electrode passes through the opening for
the electrode. Make sure the burner head
lies flat on the stove top.
Burner cap
Match the burner caps to the burners by
size, and then reinstall the caps on the
burner heads.
CAUTION
Make sure each cap is reinstalled on the
correct burner head, is centered on the
burner head, and lies flat.
CAUTION
Burner Head
Make sure all burner components (heads
and caps) are reinstalled properly. They
will be stable and rest flat when correctly
installed.
Burner cap