LG DLG8401WE Owner's Manual page 18

18 INSTALLATION
5) Mount the lower hinge bracket and the
filler on the left side of the door with the
screw removed in a previous step.
11
Install the side lock rod.
f
• Flip the side lock rod over and install it on
the opposite side. Insert the lower end into
the left hinge and lower the rod into the
guides on the door while compressing the
spring inside the recess.
• Make sure the top of the side lock rod is
beside the top lock rod and the two do not
overlap each other, so the two rods can
interact correctly. If they are not aligned
properly, the door will not operate properly.
※ A detailed diagram and identification of the inner structure and parts of the door
12
Reinstall the side interlock button.
d
• Reinstall the
d
removed in step 3. Center the spring in the
compartment and insert the interlock
button on top of it.
13
Reinstall the door cover.
• Clean the glass on the door and door cover,
if necessary. Make sure the three gray
interlock buttons are properly installed and
that the top and side lock rods are properly
aligned where they meet. Carefully lower
the door cover into place, aligning the holes
in the cover with the interlock buttons on
the top and side and the bumpers on the
bottom. Take care not to dislodge the lock
rods while mounting the door cover. Once
the door cover is in place, secure it with the
12 screws removed in step 1. The ten similar
screws go around the top and sides of the
door cover. Make sure to install the two
different screws on the bottom edge, in the
locations marked below.
side interlock button