Advertisement
2.1.1 Current SFP Options
2.1.1.1 SFP-SMF10
Net to Net's small form factor pluggable, single-mode fiber module is required for single-
mode fiber connections with the UIM-1000F. The SFP-SMF10 supports 1000Base-LX
(long haul) connections with a maximum reach of 10 kilometers.
2.1.1.2 SFP-MMF
Net to Net's small form factor pluggable, multi-mode fiber module is required for multi-
mode fiber connections with the UIM-1000F. The SFP-MMF supports 1000Base-SX
(short-haul) connections with a maximum reach of 500 meters.
2.1.2 SFP Installation
Install the SFP with the transmit and receive arrow indicators facing LEFT on a UIM-1000F
installed (in a MUM2000-2) in an IPD12000. The SFP should be installed with the transmit
and receive arrows facing UP on a UIM-1000F installed (in a MUM2000-2) in an IPD4000.
Gently slide the SFP module into the UIM-1000F SFP socket until it clicks into place.
2.2 Connect the Fiber Cable
Plug the Duplex-LC connector of your fiber cable into the SFP module installed in the UIM-1000F:
single mode fiber cables must be plugged into an SFP-SMF10 and multi-mode fiber cables must be
plugged into an SFP-MMF.
Verify the connection: solid illumination of the Lnk (link) LED on the UIM-1000F faceplate indicates a
1 Gbps, full duplex Ethernet uplink connection has been established.
3.0 ADDITIONAL INFORMATION
3.1 LED Indications
LED
Act
(Activity)
Lnk (Link)
220-0000080 rev 01
State
Indication
flashing
Ethernet activity
amber
solid amber
heavy Ethernet activity
no
no Ethernet activity
illumination
solid green
Fiber uplink connection is
established
no
no Fiber connection
illumination
Additional Information
Traffic is flowing across a 1 Gbps, full duplex
fiber connection.
An unusually large amount of traffic is flowing
across the fiber connection.
No current traffic flow across the fiber
connection.
A 1 Gbps, full duplex Ethernet uplink connection
has been established.
Advertisement
