Features
•
Set for refilling fluids such as ATF, gear oil and differential oil.
•
Especially designed for vehicles without a transmission dipstick.
•
A combination of pneumatic and manual functions allow energy-saving work and precise
refilling.
•
12.5L large tank suitable for transmissions that require large refill volume.
Safety Precautions
•
Always read the instructions carefully before using the tool
•
This tool set is for refilling ATF, gear oil and differential oil ONLY
•
DO NOT use this tool for refilling other types of oil or fluid
•
Always ensure pressure is adequately released after work
•
Ensure the working area has adequate lighting
•
Keep children and unauthorized persons away from the working area
•
Keep working area clean and tidy, dry and free from unrelated materials
•
DO NOT allow untrained persons to use this tool kit
•
Always wear eye protection that meets OSHA and ANSI Z87.1 standards
•
Always wear gloves when working with the tool
•
Always wear ear protection
•
Disposal: Customers should follow local regulations or entrust local organization to
handle used/wasted fluids
Specifications
A
Square Handle
B
Manual Pumping Handle
C
Connector to Hose
D
Pressure Gauge
E
Auto Pressure Release
F
Fluid Refill Cap
G
Tank
H
Shop Air Switch
I
Shop Air Connector
J
Pressure Regulator
K
Wire Reinforced Hose
L
Connector to Tank
M
Connector to Adapter
N
Hose Switch
Pull backward to release pressure
One stroke about 0.1 liter
Male M20 × 2.0
0-35 psi / 0-2.5 kg/cm²
Preset at 14.2 psi / 1.0 kg/cm²
Open for refilling new fluid
12.5 liter / 3.3 US Quart
Control compressed air
Standard shop air connector
7-28.5 psi / 0.5-2.0 kg/cm²
1.5m / 59" in length
Female M20 × 2.0
Female Ø9.5mm
Open for introducing new fluid
Instructions
Installation
1
Open fluid refill cap (F) and refill ATF, gear oil or differential oil to the required volume. Refer to
auto manufacturer's service manual for adequate volume.
2
Remove drain plug on transmission, gearbox or differential to drain fluids inside, and screw
back the drain plug after draining.
3
Hook up the adaptor to the connector (M) (Fig. 1).
4
Connect hose and tank together (Connect L to C) (Fig. 2).
5
Connect refill adapter to filling hole on transmission, gearbox or differential (Fig. 3).
Operation
1
Connect shop air connector (I) to shop air.
2
Turn on shop air switch (H).
3
Turn on hose switch (N), the fluid will be introduced to transmission, gearbox or differential.
4
Before all fluid is almost introduced, turn off the hose switch (N) and shop air switch (H).
5
Pull square handle (A) backward, and the pressure inside the tank will be released (Fig. 4).
6
Lift up manual pumping handle (B) (Fig. 5), and start pumping fluid manually till the
transmission, gearbox or differential is filled with adequate volume.