Alabazar EPA Series Instruction Manual

2,40 FHSS Technologv
EPAEdillon
3-ChanneI2.4G Radio Control System
INSTRUCTION MANUAL
.• Thank you for purchasing our R/C system.
• Befare using, read this manual caretully.
ee
t
e o
CAUTION
tf?
To work your R/C with your modeis correctly and sately, read this
manual carefully and keep it in a safe way as a reference introduction in the
future.
Warning:
1. This produet is only equipped for radio controlled modeis;
2. The usage af this produet should be approvsd by local relevant law ar
regulations;
3. We will not be responsible for the damages caused by unauthorized
modification, adjustment ar replacement af parts af this product;
4. The manual may be altered without prior notice. Please contact us if
vou have any corrections ar clarifications that should be made in the manual.
tf?
Befare starting the transmitter, make sure the transmitter batteries are
wellloaded .The voltage af transmitter batteries is never lower than B.6V. And
please check and confirm that the servos are all well and properlv connected.
tf?
Keep the radio system away from rnoist, high temperature and strong
shake, Do not clean the produet with solvent
tf?
The antenna does not touch anything else when power switch is turned
an. Do not leave this produet and its accessaries within the reach af small
eliildren.
tf?
Please .use this produet according to vour local relevant law ar
regulation, we are not responsible for any incidents ar damanes.
2.4G Bindin And Reducin
ower
Power sw(turn an )
----=e
1. Reducing output power setting
1).Keeping RF- TEST button till the "ST.DT" ucht turn an RED,meanwhile
the output power af transmitter reduce to lower mode 1Bdbm,which
done can save the power consumption.
2).When press the RF- TEST button again, the "ST.DT" light turn off, and
output power becomes normal 20dBm which can control more range.
2. The Binding processing
Turn an the transmitter, then connect the power ol receiver keeping the
receiver "BIND" button till the light turn an GREEN which means the
binding is successluI. Alter that, it's unnecessary to bind auain.
Caution: making sure that the RX and TX is ane meter away, and
around 10 meters no similar device.
If the light tlashlnu, showing the binding failure, please do again as
above indication.
AUX Channel Function CH3
Aux SW in "AUX", servo moving clockwise. In" OFF' ,anticlockwise.
'----J
LEFT
\..0 O..J
RIGHT
Function
BACK FIVD
Using this function to adiust servo trave I.
SERVO
the default is 100%, adjusting value range:20%-120%.
Setting
1,Pesss INC button ,the "ST.DR" LED flash in green,shown the steering
servo af value respond increased.
when LED appears all along RED, shown reach max value
2,Press DEC button , the "ST.DR" LED flash in green,shown the
steering servo af value respond decreased. when LED appears all along
RED, shown reach min value.
3,when setting D/R value, shown 20%,100%,120%.the LED appear
RED, normally the LED turn off.
iCaution:
Keeping INC and DEC at the same time, reset the transmitter.
ifo the F/S lunetion, need to be reset analn.
Function
This F/S Function is proteet your car ar boat ,when the signal become
weak ar last
How to Set
1 Make sure the RX power is enough.
2 Put trigger in brake position(above show),keep the F/S button till
"ST. DR" led flash
3 Then release F/S button, the function finished.