Technics DC SERVO SL-BD20D Operating Instructions Manual page 7

Caution for AC mains lead (or united Kingdom)
(EB" area code model only}
The configuration of AC power supply cord has been
changad.
For your safety, please read the following text carefully.
This appliance is supplied with a moulded three pin mains
piug fo' your safety and convenlence,
A 5-arpere fuse is fitted in this plug.
Should the fuse need to be replaced please ensure that the
replacement fuse has a rating of 5-ampere and that it is
approved by ASTA or BSI to BS1362.
Check for the ASTA mark @> or the BSI mark Gon the body
of the fuse.
If the p'ug contains a removable fuse cover you must ensure
that it is refitted when the fuse is replaced.
If you lase the fuse cover the plug must not be used until a
replacement cover is obtained.
A replacement fuse cover can be purchased from your local
dealer.
CAUTION! |
IF THE FITTED MOULDED PLUG IS UNSUITABLE §
FOR THE SOCKET OUTLET IN YOUR HOME THEN
THE FUSE SHOULD BE REMOVED AND THE :
PLUG CUT OFF AND DISPOSED OF SAFELY... |
THERE IS A DANGER OF SEVERE ELECTRICAL |
SHOCK IF THE CUT OFF PLUG IS INSERTED
INTO ANY 13-AMPERE SOCKET.
If a new plug is to be fitted please observe the wiring code as
shown below.
If in anv doubt please consult a qualified electrician.
IMPORTANT
The wires in this mains lead are coloured in accordance with
the following code:
Blue: Neutral
Brown: Live
As the colours of the wires in the malns lead of this
appliance may not correspond with the coloured markings
identifying the terminals in your plug, proceed as follows:
The wire which is coloured BLUE must be connected to the
terminal in the plug which is marked with the letter N or
coloured BLACK.
The wire which is coloured BROWN must be connected to
the terminal in the plug which is marked with the letter L or
coloured RED.
Under na circumstances should either of these wires be
connected to the earth terminal of the three pin plug, marked
with the letter E or the Earth Symbol —-
Before use
Remove the connector cover as follows.
Connector
How to replace the fuse
1. Remove the fuse cover with a screwdriver.
Fuse
(5 ampere)
RQCS0023
Fo893Yo