Page 2
Titan Flex Assembly Titan Flex Titan Partial Finger Assembly 1. Titan Partial Assembly 2. Tabs 3. Grip Tip Titan Thumb Assembly 1. Titan Thumb Assembly 2. Grip Tip...
Page 3
Do not disassemble. Positioning the Finger (Titan Flex) The Titan Flex can be positioned in several ways: Option 1- Connect cable to loop and a pull on the cable will cause fingers to automatically flex. The cable is typically connected to a forearm cuff and wrist flexion would apply tension to the cable.
Page 4
Positioning the Finger (Titan Partial Finger) Apply pressure to the back To return the fingertip back to of the fingertip, which the extended position, dislocate causes the fingertip to the tip section from the base by ratchet into flexion. Once pulling on the tip section.
Page 5
Repairs/Replacements Replacing the Fingertip - Due to wear and tear, a fingertip may become damaged and need to be replaced. Fingertips are available as replacement parts. Secure finger and using a Wedge a flat-edge screw dremel tool cut a channel driver into the slot created down the length of the tip.
Cautions/Warnings • Do not expose this product to corrosive or caustic materials, salt water or pH and temperature extremes. • New users should start with a wearing schedule and ease in to a full day of use. • Do not apply Loctite to fasteners unless indicated in the instructions.