Advertisement
www.costway.com
USER'S MANUAL
Portable Flux Core MIG Welder
ET1406US
THIS INSTRUCTION BOOKLET CONTAINS IMPORTANT SAFETY INFORMATION. PLEASE READ AND KEEP FOR FUTURE REFERENCE.
Follow Costway
Please give us a chance to make it right and do better！
Visit us: www.costway.com
Contact our friendly customer service department for help first.
Replacements for missing or damaged parts will be shipped ASAP!
Advertisement
Table of Contents
Subscribe to Our Youtube Channel
Related Manuals for Costway IRONMAX ET1406US
Summary of Contents for Costway IRONMAX ET1406US
- Page 1 THIS INSTRUCTION BOOKLET CONTAINS IMPORTANT SAFETY INFORMATION. PLEASE READ AND KEEP FOR FUTURE REFERENCE. Follow Costway Please give us a chance to make it right and do better！ Visit us: www.costway.com Contact our friendly customer service department for help first. Replacements for missing or damaged parts will be shipped ASAP!
-
Page 2: Safety Information
SPOOL, ADJUSTING WIRE TENSION ROLLER OR REPLACING CONTACT TIP. E-mail 4.THE GAS NOZZLE MUST ALWAYS BE INSTALLED WHEN WELDING-DO NOT WELD US: cs.us@costway.com WITHOUT THE GAS NOZZLE IN PLACE. THE CONTACT TIP IS ELECTRICALLY “HOT” UK: cs.uk@costway.com AND IF IT CONTACTS THE GROUNDED WORK PIECE IT WILL CAUSE DAMAGE. -
Page 3: Product Introduction
PRODUCT INTRODUCTION PANELS ILLUSTATION The working principle of Synergic Co2 gas shield Mig welder is to rectify AC input current to direct current, and then use high power IGBT to invert direct current to high frequency Ac current and then reduce voltage and rectify. -
Page 4: How To Assemble
MIG140 welder is of no gas (flux) function. It could weld max 1kgs welding wire . Please be reminded to assemble the correct size of wire in usage. INSTALLING THE WIRE It is also reminded the nozzle size and wire roller size should be same. For example, 1.0mm wire The MIG140 could be used with a 10cm diameter wire spool only. -
Page 5: Check Fault
3.0" long. CHECK FAULT 7. Thread the welding wire through the Guide Pipe (PIC. C-C4) and over the wire Drive Roller and into the torch hole. 8. Reattach the Rocker arm and reset the Pressure Adjuster. - Page 6 February 24, 2019 Great products so far. Fast delivery, easy setup, and working without any issues. With your inspiring rating, COSTWAY will be more consistent to offer you EASY SHOPPING EXPERIENCE, GOOD PRODUCTS and EFFICIENT SERVICE! US office: Fontana, California...
Need help?
Do you have a question about the IRONMAX ET1406US and is the answer not in the manual?
Questions and answers