Advertisement
REAR PANEL
33 34 35
33. Record line input
34. Audio output 1
35. Audio output 2
BASIC OPERATIONS
Make sure that power to both the deck and your ampli er/receiver is turned o
before making any connections. If the deck is placed near an ampli er, TV or
tuner, noise (induced hum) or beat interference may result. If this occurs, place
the deck further away from other components or reorient its position.
C-120 cassette tapes are not recommended as they use a very thin tape base
which may become tangled around the capstan or pinch roller.
1. Press POWER button.
3. Insert the cassette with the exposed tape side facing
down. To close the compartment, push the section of
the compartment door until it locks shut.
4. Press the PLAY button to play.
A
B
4
www.PyleUSA.com
36
36. Connect with ground
37. AC 110V power input
2. Press STOP/EJ button to open
the deck.
5. Press DIR button to change
the direction of movement
in deck A.
7. Press the REW button
for rewinding.
9. Press PAUSE button in
the B deck to pause.
37
HOW TO RECORD?
Before putting a tape into the deck, take up any slack
with a pencil or your nger tip. This precaution prevents
the tape from becoming entangled around the
capstan or pinch roller.
HOW TO SELECT THE RECORDING SOURCE?
1. Choose deck A to be the source. Just play the tape in it for recording.
LINE
2.
Choose LINE to record from program source.
3. Choose deck A and LINE to be the source for mix recording.
HOW TO SET THE RECORDING ELECTRIC LEVEL?
Use the right and left electric level control knobs to adjust the level.
Usually turning the indicator to the middle works very well.
In the recording mode, press
REC function button to select
tape type.
6. Press the MODE button to choose
play one-side or both sides.
8. Press FF button for fast-forward.
10. Press DNR ON button to
automatically enter digital noise
reducing. Press OFF to stop.
In the playing mode, press PLAY
function button to select tape type.
www.PyleUSA.com
5
Advertisement
