SAFETY INSTRUCTIONS To prevent injury and property damage, please follow the below instructions when using the dehumidifier. Children shall not play with the appliance. This appliance can be used by children aged 8 years or above and persons with reduced physical,...
Page 4
Please read this manual carefully and fully understand it before operating your appliance. Always operate the unit from a power source of equal voltage, frequency, and rating as indicated on the product identification plate. Unplug the power cord when cleaning or when not in use. Do not unplug while the unit is operating.
PARTS DESCRIPTION Handle Control Panel Air Inlet Grille Power Cord Filter Drainage Port Wheels Air Outlet Lift Handle Power Cord (Both Sides) Hooks Grille Drainage Hose Screws x 2 (for the handle installation)
SPECIFICATIONS Product Name Dehumidifier Model GL150P Voltage 115V 60Hz 762W/6.8A @ 80˚F, 60% RH Rated Power 970W/8.7A @ 86˚F, 80% RH 1229W/11A @ 95˚F, 90% RH Air Circulation 276 CFM Refrigerant R32/10.59 oz Noise ≤52dB(A) Work Temperature 41-95˚F OPERATION Place the dehumidifier in a horizontal...
Page 7
Install the Handle Tighten the included screws on both sides to fasten the handle in place as shown in the picture below. Please note to align the holes on the handle with the holes on the dehumidifier. Drainage This dehumidifier has an internal pump that will automatically drain water...
Page 8
Control Panel Press this button to turn on the unit. The screen displays the current humidity and enters continuous mode by default with the “CONTINUOUS” light on. Press it again to turn o the unit. The screen will display the current humidity with half-dim light.
Page 9
Long press Timer and Power buttons at the same time for 3 seconds to show the current temperature. After 10 seconds the display will return to show the current humidity. Press the button to set the continuous mode. The screen will display the current humidity and the “CONTINUOUS”...
CLEANING Clean the machine with a soft wet cloth as needed. Open the front panel and pull the filter out. Use a clean cloth to clean the surface dust on the filter. If the filter is extremely dirty, use tap water to flush the filter. Fully dry the filter before putting it back into the dehumidifier.
If it is displayed What does it mean? Temperature sensor failure. If it is displayed, E1, E2 contact TURBRO service team. Water is full, press the "DRAIN" button to remove water. If this continues to display, contact TURBRO service team.
TROUBLESHOOTING Troubleshoot your problem by using the chart below. If the dehumidifier still does not work properly, please contact TURBRO customer team via support@turbro.com. Issues POSSIBLE CAUSE POSSIBLE REMEDY A. Did not plug into the A. Plug into the required electrical outlet.
WARRANTY TURBRO provides a 1-year limited warranty for TURBRO products from the date of purchase, subject to the following conditions and limitations outlined below. What is covered? This warranty is limited to the repair or replacement of part(s) proved to be defective in material or workmanship, after said defect is confirmed...
Need help?
Do you have a question about the Greenland GL150P and is the answer not in the manual?
Questions and answers