Subscribe to Our Youtube Channel
Summary of Contents for Chery CherryMAX G746A
- Page 1 ORIGINAL INSTRUCTIONS G746A CherryMAX® Power Riveter N S N 5130-01-338-3403 1224 East Warner Ave, Santa Ana, CA 92705 Tel: 1-714-545-5511 Fax: 1-714-850-6093 Page 0 www.cherryaerospace.com...
- Page 2 This page was left intentionally blank. Page 1...
-
Page 3: Table Of Contents
T H E G 7 4 6 A T O O L TABLE OF CONTENTS Description ....................................2 Specifications ..................................2 Safety Warnings ..................................3 Riveter usage ................................... 4 Maintenance and Repair ................................. 4 Fill and Bleed Instructions ............................... 5 Trouble Shooting .................................. -
Page 4: Safety Warnings
SAFETY WARNINGS Operating this tool with a damaged or missing stem deflector, or using the deflector as a handle, may result in severe personal injury. The pin deflector should be rotated until the aperture is facing away from the operator and other persons working in the vicinity. -
Page 5: Riveter Usage
MAINTENANCE AND REPAIR The G746A has been manufactured to give maximum service with minimum care. In order that this may be accomplished, the following recommendations should be followed: 1. The hydraulic system should be full of oil and free from air at all times. -
Page 6: Fill And Bleed Instructions
F I L L A N D B L E E D I N S T R U C T I O N S To replace a small amount of oil in the tool, connect the tool to the air line, remove cap screw (15). (CAUTION: Do not depress trigger without cap screw or air bleeder attached.) Attach the Cherry air bleeder (700A77), and slowly cycle tool several times. -
Page 7: Overhaul
OVERHAUL G 7 0 1 / G 7 0 4 K T T O O L K I T CAUTION: Always disconnect the air supply before overhaul maintenance. disassembly and reassembly procedures can be accomplished by following the instructions below and the drawings on pages 9 &... -
Page 8: Handle Sub-Assembly
H A N D L E S U B - AS S E M B L Y Disconnect tool from air supply. Holding tool upright, remove four socket-head cap screws (49). Lift head assembly from handle (18) and set aside O- ring (50) and gasket (51). -
Page 9: Cross Section Drawing
G 7 4 6 A C R O S S S E C T I O N AL V I E W Page 8... -
Page 10: Parts List
G 7 4 6 A P AR T S L I S T ITEM NO. DESCRIPTION QTY. 845-016 SUB-ASSEMBLY, HEAD 845-019 SUB-ASSEMBLY, HEAD CYLINDER 845-018 CYLINDER, HEAD 845B6 FITTING, NOSE P-701 0-RING P-998 RING, BACK-UP 845-017 PISTON, HEAD P-304 RING, QUAD (.943, .737, .103) P-106 RING, BACK-UP (.926, .750, .088) P-848... -
Page 11: Exploded View
G 7 4 6 A E X P L O D E D V I E W Page 10... -
Page 12: Declaration Of Conformity
Declaration of Conformity We, Cherry® Aerospace, 1224 E. Warner Ave., Santa Ana, CA 92705 declare under our sole responsibility that the product type G746A Serial No.- to which this declaration relates is in conformity with the following standards EN292 part 1 and part 2 ISO 8662 Part 1 ISO 3744 following the provisions of the Machine Directive 89/392/EEC...
Need help?
Do you have a question about the CherryMAX G746A and is the answer not in the manual?
Questions and answers