Advertisement
4.
OPERATION
WARNING! Ensure you read, understand and apply the safety instructions before use.
‰
WARNING! Before use, ensure that the motorcycle has a suitable structure and centre of gravity to accommodate the stand
‰
without damaging the bike.
DO NOT use the stand if it will foul on the exhaust or other vulnerable parts. If necessary remove any lower fairing and ensure that the
8
bike is stable on the stand before operating.
4.1.
Position the bike in a suitable area, checking that the surface on which the stand will be placed is solid and flat (preferably concrete).
4.2.
Ensure there is good access and clearance beneath the bike for the stand.
4.3.
The stand can be also be used in conjunction with a motorcycle that is already raised on a motorcycle lift.
4.4.
Ensure that the stand is centrally located on the lift platform.
4.5.
Inspect the underside of the motorcycle for suitable support points, bearing in mind the centre of gravity of the motorcycle and which
wheel is to be lifted from the ground.
4.6.
Place the stand under the motorcycle in the approximate position required.
4.7.
Turn the handle clockwise to raise the stand until the platform is in contact with the underside of the motorcycle. Adjust the position of the
stand as necessary and proceed to raise the bike.
4.8.
For additional security it is advisable to retain the motorcycle on the stand with suitable straps, especially if the motorcycle is already
raised from the ground on a motorcycle lift.
4.9.
When work is complete, check under the stand to ensure that there are no obstructions and that it is safe to lower the unit.
4.10.
When the stand is fully lowered, ensure that the bike is standing on its wheels and is supported in the upright position.
5.
MAINTENANCE
5.1.
When the stand is not in use, store it in the lowered position.
5.2.
Keep the stand clean and wipe off any oil or grease. Lubricate all moving parts with oil.
5.3.
Before each use check all parts. If any part of the stand is damaged or defective, remove the stand from service and take the
necessary action to remedy the problem.
DO NOT use the stand if it is believed to have been subjected to abnormal load or shock. Inspect and take appropriate action.
8
T-Bar and socket
not shown
5.4.
5.5.
.
ENVIRONMENT PROTECTION
Recycle unwanted materials instead of disposing of them as waste. All tools, accessories and packaging should be
sorted, taken to a recycling centre and disposed of in a manner which is compatible with the environment. When
the product becomes completely unserviceable and requires disposal, drain any fluids (if applicable) into approved
containers and dispose of the product and fluids according to local regulations.
NOTE: It is our policy to continually improve products and as such we reserve the right to alter data, specifications and component parts
without prior notice.
IMPORTANT: No Liability is accepted for incorrect use of this product.
WARRANTY: Guarantee is 12 months from purchase date, proof of which is required for any claim.
Sealey Group, Kempson Way, Suffolk Business Park, Bury St Edmunds, Suffolk. IP32 7AR
01284 757500
© Jack Sealey Limited
sales@sealey.co.uk
Original Language Version
www.sealey.co.uk
MC5908.V2
Issue:2 (1) 16/11/23
Advertisement
