Troubleshooting - Arctic King ARU07M2AWW Instruction Manual

4. TROUBLESHOOTING

The following issues can be handled by the user. Please call the after-sale service department if the issues
are not resolved.
Unit not operating
Odors
Long-term operation of
compressor
The freezer door does not
properly close
Loud noise
Door opening
Freezer enclosure
heat/ Condensation
Airflow sound, Buzz and
Clatter
.
Not plugged in.

The circuit breaker tripped or has a blown fuse.

 The freezer temperature control is set at "OFF".
 Odorous foods should be thoroughly wrapped
 Foods are rotten
 Unit should be cleaned.
The room temperature is hotter than normal.

A large amount of food has been added to the freezer.

The door is opened too often.

The door is not entirely closed.

The temperature control is not set correctly.

 The door gasket does not seal properly.
 The freezer does not have the correct clearances.
The freezer has recently been disconnected for a period of time. Four

hours are required for the freezer to cool down completely.
 The freezer is not leveled.
 The gasket is dirty.
The freezer is not leveled correctly

Check if accessories are correctly positioned and do not vibrate.

After refrigeration, there will be pressure difference between the inside and

outside of the freezer and door may not open easily. This is a normal
physical phenomenon.
 The freezer enclosure may emit heat during operation specially in summer,
this is caused by the radiation of the condenser, and it is a normal
phenomenon.
Condensation: condensation can be detected on the exterior surface and

door seals of the freezer when the ambient humidity is high, this is a normal
phenomenon, and the condensation can be wiped away with a dry towel.
 Refrigerants circulating in the tubes will produce sounds and grunts. This is
normal and does not affect the cooling effect.
 The running compressor will buzz especially when starting up or shutting
down.
 The solenoid valve or electric switch valve can clatter which is a normal
phenomenon and does not affect the operation.
13