Electrolux LNT6TE18S5 User Manual page 20

Problem
Water flows on the floor.
Temperature cannot be set.
The temperature in the appliance is
too low/too high.
DEMO appears on the display.
A or or symbol is shown
instead of numbers on the tempera‐
ture display.
If the advice does not lead to the desired
result, call the nearest Authorized
Service Centre.
8.2 Replacing the lamp
The appliance is equipped with a longlife LED
interior light.
Only service is allowed to replace the lighting
device. Contact your Authorised Service
Centre.
20 ENGLISH
Possible cause
The melting water outlet is not con‐
nected to the evaporative tray above
the compressor.
The FastFreeze function or Fast‐
Cool function is switched on.
The temperature is not set correctly. Set a higher/lower temperature.
The door is not closed correctly.
The food products' temperature is
too high.
Many food products are stored at
the same time.
The door has been opened often.
The FastFreeze function is switched
on.
The FastCool function is switched
on.
There is no cold air circulation in the
appliance.
The appliance is in the demonstra‐
tion mode.
Temperature sensor problem.
8.3 Closing the door
1. Clean the door gaskets.
2. If necessary, adjust the door. Refer to
3. If necessary, replace the defective door
Solution
Attach the melting water outlet to
the evaporative tray.
Switch off FastFreeze function or
FastCool function manually, or wait
until the function deactivates auto‐
matically to set the temperature. Re‐
fer to "FastFreeze function" or "Fast‐
Cool function" section.
Refer to "Closing the door" section.
Let the food products temperature
decrease to room temperature be‐
fore storage.
Store less food products at the
same time.
Open the door only if necessary.
Refer to "FastFreeze function" sec‐
tion.
Refer to "FastCool function" section.
Make sure that there is cold air cir‐
culation in the appliance. Refer to
"Hints and tips" chapter.
To exit the demonstration mode,
press and hold the OK button for ap‐
proximately 10 seconds until you
hear a long sound and the display
turns off for a short time.
Contact the nearest Authorized
Service Centre. The cooling system
will continue to keep food products
cold, but temperature adjustment
will not be possible.
installation instructions.
gaskets. Contact the Authorised Service
Centre.