Table of Contents
Advertisement
Section 3- MAINTENANCE
WARNING
DO NOT attempt any adjustments,
maintenance, service
or repairs with the engine running. Stop engine. Stop
blade. Engage parking brake. Remove key. Remove
spark plug wire from spark plug and secure away from
plug. Engine and components are HOT. Avoid serious
burns, allow all parts to cool before working on machine.
Fuel Filler Cap and Vent must be closed securely to
prevent fuel spillage.
3. Check fill/level plug for damage. If signs of wear or
cracks are visible, replace plug with new plug. See
Figure 3.9.
4. To check lubricant in chain case, remove fill/level
plug
and
look
for
lubricant
on
the
internal
components
of the chain case.
If no lubricant is
visible,
add SNAPPER
transmission
grease
as
needed. See Figure 3.9.
AXLE
BOOTS
\
CHAIN
CASE
FILULEVEL
PLUG
P.N, 1-1024
FIGURE 3.9
3.3.10.
Check
"MAINTENANCE
SCHEDULE"
Section of Engine Owner's
Manual for additional
engine service.
3.4
SERVICE - ANNUALLY
3.4.1.
ENGINE
1. Perform
all
maintenance
as
specified
in
"MAINTENANCE SCHEDULE" Section of this manual.
3.4.2.
FUEL FILTER
Service fuel filter as instructed
below, on COLD
ENGINE ONLY!
IMPORTANT: To stop flow of fuel, tank may be removed
from bracket and set on the floor so the fuel level will be
below the filter. Refer to Section "REMOVING FUEL TANK".
1. Remove hose clamps from fuel filter.
2. Remove fuel lines from filter. Discard filter.
3. Install new fuel filter. See Figure 3.10.
4. Reinstall fuel tank into bracket.
3.5
3.6
FUEL
P,N. 1.4369
FIGURE 3.10
EVERY TWO YEARS
In addition
to regular maintenance,
the following
components
of the Rear Engine Rider should be
carefully
inspected
every two years for wear or
damage.
Replace worn or damaged
parts with
genuine
SNAPPER
replacement
parts
available
from an authorized SNAPPER dealer.
3.5.1.
3.5.2.
3.5.3.
3.5.4.
3.5.5.
3.5.6.
All bushings and pivot areas.
Check both front wheel king pins.
Transmission
shift lever and detent.
Clutch disc.
Clutch Yoke (See Figure 4.7).
Mower deck linkage and pivot areas.
STORAGE (OUT OF SEASON)
If desired, the Rear Engine Rider can be stored on
the rear bumper.
Perform the following procedures
to
insure
the
Rear
Engine
Rider
will
operate
properly when taken out of storage.
3.6.1. Thoroughly clean the Rear Engine Rider by
removing all grass clippings and debris.
3.6.2.
Perform
maintenance
and
lubrication
as
required.
3.6.3.
Drain fuel from fuel tank.
3.6.4.
Start engine and allow it to run until engine
runs out of fuel. This allows the carburetor and fuel
system to remain clean during storage.
3.6.5.
Remove
battery.
Refer
to
Section
"BATTERY STORAGE".
3.6.6.
Close vent on fuel filler cap.
3.6.7.
Carefully stand Rear Engine Rider on rear
bumper in desired location for storage.
17
Advertisement
Table of Contents
