Table of Contents
Advertisement
1. Important
•
Do not subject the monitor to severe
vibration or high impact conditions
during operation.
•
Do not knock or drop the monitor
during operation or transportation.
Maintenance
•
To protect your monitor from possible
damage, do not put excessive pressure
on the LCD panel. When moving your
monitor, grasp the frame to lift; do not
lift the monitor by placing your hand
or fingers on the LCD panel.
•
Oil-based cleaning solutions may
damage the plastic parts and void the
warranty.
•
Unplug the monitor if you are not
going to use it for an extensive period
of time.
•
Unplug the monitor if you need to
clean it with a slightly damp cloth. The
screen may be wiped with a dry cloth
when the power is off. However, never
use organic solvent, such as, alcohol,
or ammonia-based liquids to clean
your monitor.
•
To avoid the risk of shock or
permanent damage to the set, do
not expose the monitor to dust,
rain, water, or excessive moisture
environment.
•
If your monitor gets wet, wipe it with
dry cloth as soon as possible.
•
If foreign substance or water gets in
your monitor, please turn the power
off immediately and disconnect the
power cord. Then, remove the foreign
substance or water, and send it to the
maintenance center.
•
Do not store or use the monitor in
locations exposed to heat, direct
sunlight or extreme cold.
•
In order to maintain the best
performance of your monitor and
use it for a longer lifetime, please use
the monitor in a location that falls
within the following temperature and
humidity ranges.
• Temperature: 0-40°C 32-104°F
• Humidity: 20-80% RH
Important information for Burn-in/
Ghost image
•
Always activate a moving screen
saver program when you leave your
monitor unattended. Always activate
a periodic screen refresh application if
your monitor will display unchanging
static content. Uninterrupted display
of still or static images over an
extended period may cause "burn-
in", also known as "after-imaging" or
"ghost imaging", on your screen.
•
"Burn-in", "after-imaging", or
"ghost imaging" is a well-known
phenomenon in LCD panel
technology. In most cases, the "burn-
in" or "after-imaging" or "ghost
imaging" will disappear gradually over
a period of time after the power has
been switched off.
Warning
Failure to activate a screen saver, or a
periodic screen refresh application may
result in severe "burn-in" or "after-image"
or "ghost image" symptoms that will not
disappear and cannot be repaired. The
damage mentioned above is not covered
under your warranty.
Service
•
The casing cover should be opened
only by qualified service personnel.
•
If there is any need for any document
for repair or integration, please
contact with your local service center.
(Please refer to Service contact
information listed in Important
information manual.)
•
For transportation information, please
refer to "Technical Specifications".
2
Advertisement
Table of Contents
