Zenith IQC50H94W Operating Manual page 39

Picture-In-Picture Overview
SINGLE MODE PIP
1
Press the PIP button on your remote to
activate the PIP display. This display
appears in one corner of the screen. Press
PIP again to remove the display from the
screen.
2
Use the PIP Ch button on your remote to
switch between main picture and PIP inset
display channel tuning control.
• Main Picture channel tuning: Channels
are tuned for the main screen.
• PIP Inset Display channel tuning:
Channels are tuned for the PIP inset.
Note: Available for Antenna 1-2 sources.
3
Press the SOURCE button on your remote
when PIP display is active to change PIP
source from VID1, VID2, FRT. VID, and ANT
1 antenna source.
SURF MODE PIP
1
Press the PIP button on your remote. Press
the "Surf" button to see three PIP insets.
Surf will scan all active channel numbers
and display them as PIP displays.
2
Press PIP again to remove PIP displays
from screen.
NOTES: If Parental Control Ratings are locked, it will disable multiple PIP insets (SURF mode PIP).
206-3597-A
P A G E 3 9