Summary of Contents for Pedal Parts Repeater
- Page 1 Repeater Classic choppy sounds of the Vox Repeat Percussion Contents of this document are ©2024 Pedal Parts Ltd. No reproduction permitted without the express written permission of Pedal Parts Ltd. All rights reserved.
- Page 2 Before you dig in, ensure you download and read the General Build Guide. It contains all the information you need for a successful outcome.
- Page 3 Schematic + BOM 330K 4n7* Q1-2 MPSA18** 330K 100n 2N2646 100u elec DEPTH 500KC 220-500R Trim 10u elec RATE 100KC 2u2 elec 470R 47-50K Trim 330K Empty SPDT ON-ON This BOM represents a build using the 2N2646 UJT. These are getting scarce. See page 5 for an alternative build using the readily available 2N6027 PUT.
- Page 4 Snap the small metal tag off the pots so Use the VOL trimmer to adjust the output level they can be mounted flush in the box. you want. You should solder all other board-mounted Set your DEPTH pot to max, and adjust R10 to components before you solder the pots.
- Page 5 Using a 2N6027 Place your PUT as shown above. 1K trimmer...
-
Page 6: Drilling Template
3 mm This template is a rough guide only. You should ensure correct marking of your enclosure before drilling. You use this template at your own risk. Pedal Parts Ltd can accept no responsibility for incorrect drilling of enclosures. FuzzDog.co.uk...