IBM Selectric Manual page 44

b. New Style - The spring anchor should be adiusted
up or down so that
.00111
to
.005 11
clearance exists
between the
~pring
and the anchor, when a single
operation takes place as the spacebar is depressed
slowly (Fig.
118).
.00111
to
.005"
Vertical
Clearance
FIGURE
118.
SPacebar Repeat Stop (New Style)
6.
Spacebar Final Stop - On early level machines, adjust
the stop located on the keylever guard to obtain
.005 11
to
.020 11
clearance between the stop and the spacebar
center stem at the time a repeat operation occurs (Fig.
119).
On current level machines the final stop has been
eliminated.
Spacebar Button
Make Adjustment
Here
Keylever Guard
~
Spacebar Fina I Stop
.005"
To.
0
1
0"
Spacebar
Stem
FIGURE
119.
!:3pacebar Final Stop (Early Style)
7. Spacebar
Int~rlock
Mechanism (Old Style) - Perform the
following adjustments:
a. Lockout Cam - Ad just the escapement cam left or
right on the filter shaft so that when the lockout
cam is on the high point of the escapement cam the
lockout cam wi II have.
050"
to
.060"
latera I moti on
remaining toward the left (Fig.
120).
Be sure to maintain the proper radial position of
the escapement cam. It should be adjusted so that
the escapement cam follower is resting on, and at
the begrnning of, the low dwell of the cam when
the fi Iter shaft is in its rest position.
b. Lockout Cam Guide - Adjust the guide up or down
so that the spacebar interposer wi II be allowed to
movetotherear
.015"
to
.025"
when the interposer
is unlatched (Fig.
121).
The filter shaft must be
rotated unt i I the lockout cam moves fu" y to the
right to check this adjustment.
.050"
To
.060"
Latera I Motion
Escapement Cam
FIGURE 120. Lateral Adjustment Of
The Escapement Cam
FIGURE
121.
SPacebar Lockout Cam
Guide Adjustment
CAUTION: Make certain that the spacebar inter-
poser, when released and interlocked, clears the
cl utch release arm by
.005"
to
.025".
c. Spacebar Interposer Guide - Ad just the interposer
guide left or right to obtain
.015"
to
.025 11
clear-
ance between the interposer and the lockout cam
(Fig.
122).
The filter shaft should be in its rest
position and the spacebar interposer released to the
rear when making this adjustment.