Fault
"E:35 / -10"
flashes.
lights up.
lights up.
flashes.
While the smartFinish
programme is run-
ning, no status display
is shown on the dis-
play.
"E:30/-20"
Cause and troubleshooting
Turn off the water tap.
▶
Call the after-sales service.
▶
→ "Customer Service", Page 48
The automatic voltage control system detects an un-
authorised voltage drop.
No remedial action possible.
▶
Note: If the power supply is stable, the programme
continues to run as normal.
Voltage under-usage may cause extension of a pro-
gramme.
No remedial action possible.
Voltage under-usage may cause extension of a pro-
gramme.
No remedial action possible.
The temperature is too high.
Wait until the temperature has dropped.
▶
→ "Cancelling the programme", Page 29
▶
Water level is too high.
Select a suitable programme for draining.
▶
→ "Programmes", Page 23
Door is not closed.
Close the door.
▶
Laundry is caught in the door.
Remove any trapped laundry.
▶
This is not a washing programme, so a status display
is not provided.
Not a fault – no action required.
▶
Detergent dosage is too high.
Reduce the amount of detergent for the next wash-
▶
ing cycle with the same load.
Additional water is added.
Do not add any extra water to the appliance while it
▶
is operating.
Solenoid valve defective.
Call the after-sales service.
▶
→ "Customer Service", Page 48
Troubleshooting en
39