Table of Contents
Advertisement
Cable Service (CATV) Hook Up
Connect cable service to the TV
1
Locate the Antenna/Cable jack on the back of
the TV.
2
Connect the cable service wire that runs from
the wall, according to one of the diagrams to
the right.
3
Remove the back of the remote and put in two
AA batteries.
4
Plug in the TV. Your TV is designed to operate
on standard current, 120-volt 60 Hertz AC. Do
not attempt to operate it on DC power.
120 V AC
60 Hz
5
Go to page 12 to Auto Program the TV.
If you're using a cable box, leave the TV on channel 3
or 4 and use your cable box to change channels.
If you're using a cable box, Auto Program might only
find the channel your cable service is on (usually
channel 3 or 4). Don't worry, that's all you need!
P A G E 8
back of
remote
Cable TV
Wall Jack
RF Coaxial Wire
(75ohm)
Cable TV
Wall Jack
Cable Box
In
output
Out
switch
3 4
RF Coaxial Wire
(75 ohm)
TV Back
VIDEO
MATRIX
OUT
IN
M.P.I.
R- AUDIO- L
IN
TV Back
VIDEO
MATRIX
OUT
IN
M.P.I.
R- AUDIO- L
IN
206-3489-O
Advertisement
Table of Contents
