Hook Up Your Antenna To The Tv - Zenith A19A11D Operating Manual

P A G E 4 I N S TA L L AT I O N

Hook Up Your Antenna to the TV

Connect an
1
off-air antenna
to your
Entertainment
Machine.
2
3
4
5
Mini glossary
75 OHM RF CABLE
300 TO 75 OHM ADAPTER
S TA N DA R D
Locate the Antenna/Cable jack on
the back of your Entertainment
Machine.
Connect the cable that runs from
the wall directly to this jack,
according to the diagram to the
right.
Remove the back of the remote
and put in two AA batteries.
back of remote
Plug in your TV. Do not plug it
into a switched outlet. Your
Entertainment Machine is
designed to operate on household
current, 120-volt 60 Hertz AC do
not attempt to operate it on DC
Current.
Go to page 8 to Auto Program
your Entertainment Machine.
If you have a 75 ohm RF cable,
then you don't need any adapters!
Remember, when screwing RF
cables onto jacks, clockwise tight-
ens, and counterclockwise loosens.
A 300 to 75 ohm adapter is not
included with your Entertainment
Machine.
The wire that comes from an off-air antenna or cable service provider. Each end looks like a hex shaped nut with a wire
sticking through the middle, and it screws onto the threaded jack on the back of your TV.
A small device that connects a two-wire 300 ohm antenna to a 75 ohm RF jack. They are usually about an
inch long with two screws on one end and a round opening with a wire sticking out on the other end.
Flat wire antenna to TV
Antenna
Flat wire
(300 ohm)
Antenna to TV Coaxial wire
Antenna
RF coaxial wire
(75ohm)
TV back
TV back panel
(expanded view)
Audio In Video
Antenna
Cable
300/75 ohm
Adapter
TV back
TV back panel
(expanded view)
Audio In Video
Antenna
Cable
206-3370-A