Hook Up Antenna And Vcr To The Tv - Zenith A19A02D Operating Manual

P A G E 6 I N S TA L L AT I O N

Hook Up Antenna and VCR to the TV

Connect your
off-air
antenna and
VCR to your
1
Entertainment
Machine.
2
3
4
5
S TA N DA R D
Locate the Antenna/Cable jack on
the back of your Entertainment
Machine.
Connect the cable that runs from
the wall directly to this jack,
according to the diagram to the
right.
Remove the back of the remote
and put in two AA batteries.
back of remote
Plug in your TV. Do not plug it
into a switched outlet. Your
Entertainment Machine is
designed to operate on household
current, 120-volt 60 Hertz AC do
not attempt to operate it on DC
Current.
Go to page 8 to Auto Program
your Entertainment Machine.
Remember, when screwing
RF cables onto jacks, clockwise
tightens, and counterclockwise
loosens.
No A/V cables are included
with your Zenith Entertainment
Machine.
Without A/V cables, most VCRs will
not play videocassettes in stereo
sound.
Flat wire Antenna to TV with VCR
Antenna
Flat wire
(300ohm)
300/75 ohm
Adapter
TV back
RF coaxial wire (75ohm)
not included with TV
TV back panel
(expanded view)
Antenna
Cable
Coaxial wire Antenna to TV with VCR
Antenna
RF coaxial wire (75 ohm)
not included with TV
TV back
TV back panel
(expanded view)
Antenna
Cable
VCR back
VCR back AV panel
Output
In
3 4
switch
Out
Video Audio
VCR back
VCR back AV panel
Output
In
3 4
switch
Out
Video Audio
RF coaxial wire (75 ohm)
not included with TV
206-3369-A