AEG T56800 User Information page 21

Problem
When pressing a but-
ton, the corresponding
button flashes several
times.
Drum light does not
work.
Programme inactive,
EMPTY WATER display
illuminated.
Drying cycle ends
shortly after pro-
gramme starts. END
display illuminated.
Drying cycle lasts an
unusually long time.
Note:
After up to 5 hours the
drying cycle finishes
automatically
(see "Drying cycle
complete").
Possible cause
Washing protection. After
the start of the programme,
the option can no longer be
set.
Programme selector in OFF
position.
Defective lamp.
Condensate tank is full.
Not enough washing load-
ed or washing loaded is too
dry for selected programme.
Lint filter clogged.
Heat exchanger clogged
with lint.
SPECIAL CARE button
pressed and load volume too
big.
Load volume too big.
Laundry insufficiently spun.
Remedy
Turn the programme knob to
OFF. Set the programme again.
Turn programme selector to
LIGHT or to any programme.
Replace lamp (see next sec-
tion).
Empty condensate tank, then
start programme with START/
PAUSE button.
Select time programme or
higher drying level (e.g. INTEN-
SIVE DRY instead of STORAGE
DRY).
Clean lint filter.
Clean heat exchanger.
SPECIAL CARE is only suitable
for use with loads of up to
3kg!
Reduce load volume.
Laundry must be adequately
spun.
21