Consult the dealer or an experienced radio/TV technician for help. • CAUTION: Do not attempt to modify this product in any way (except as noted herein) without written authorization from Zenith Electronics Corporation. Unauthorized modification could void the user’s authority to operate this product. PCZ3000-WARN 1/00...
Remove Old Card CAUTION: Disconnect the TV power cord from power outlet before removing screws and old card. Using a small phillips-head screwdriver, remove the two screws holding in the VGA card on the jack panel. Grasping the removal hook provided firmly, remove the VGA connector card. P A G E 4 COMPUTER RIGHT...
Install New Conversion Card CAUTION: Be sure the power cord is disconnected before installing the new conversion card. Align the new scan card edge with the slots in the jack panel, guide the new card into the open slot where the old card was. Push card in firmly enough to be sure it snaps into position. Reinstall the two screws on the jack panel.
15-ft. cable with a “video-mirror”, The cable is used to provide a computer image to two monitors—your computer’s monitor and your Zenith Presentation TV. Make the connections with the 15-ft. “video-mirror” cable* as shown. Also refer to the preceding page for audio connections and “Using the monitor function.”...
Page 7
Hook Up a Computer to your TV After all connections are made, follow instructions below to select Computer source to show your computer’s image on the screen Make the basic connections as indicated. (Appearance of compo- nents may vary from those in the illustrations.) Plug in your TV.
Remote Key Command Functions While your Presentation TV is in Rear Computer Mode, the table below lists the commands used to make adjustments to the screen. The following remote keys apply ONLY to the NUMBER keypad. Remote Key †Auto Screen Size †...
Remote Key Command Functions The table below illustrates the menu structure for your Presentation TV while in Rear Computer mode. As with the Remote Key Command Functions, menus are operated through the NUMBER keypad. Generally speaking, keys 4 and 6 adjust menu options, key 8 cycles through menus and Menu Adjust: Menu Adjust: H.
Troubleshooting Troubleshooting Problem Possible Cause(s) Installation Old card is hard • Screws not removed. to remove. • Snug fit. Green light is not lit • Card not completely installed. -Be sure card is firmly seated into internal connectors. when TV power is restored and TV is on.
Page 11
Setup for Looping-Out S-Video/Video Computer Image to a Master TV & other TVs 1. With the Computer and TV disconnected from power and the PCZ3000 Scan Conversion Card installed, make S-Video or Video connections as shown. 2. Connect Computer and TV(s) to power, first turn on the PCZTV, TVs, and then the Computer.
Direct-View Color TV Welcome to the Zenith family! We believe that you will be pleased with your new Zenith TV. Please read this warranty carefully, it is a “LIMITED WARRANTY” as defined under Federal Law. This warranty gives you specific legal rights, and you may also have other rights that vary from state-to-state within the U.S.A.