Advertisement
WARNING! Ensure the lantern is correctly charged before initial use.
DO NOT allow children to use the lantern.
DO NOT use if the battery or the lantern casing is damaged.
When not in use store the lantern in a safe, dry, childproof location.
1.3. BATTERY SAFETY INSTRUCTIONS
WARNING! Powered by a sealed lead-acid battery which can be dangerous if not handled with care.
Charge battery prior to first use. The battery pack will have been shipped in a low charge state. Minimum
initial charge time 20 hours.
DO NOT charge battery when room temperature is below 50°F (10°C) or above 104OF (40°C).
DO NOT attempt to recharge the battery by means of an engine generator or a DC power source.
DO NOT short-circuit the battery by linking both terminals with a metal object.
DO NOT store the battery (or lantern) in locations where the temperature may exceed 104°F (40°C) such
as outside sheds, above heaters, or metal buildings in summer.
WARNING! Dispose of spent battery correctly and in accordance with local regulations as it
contains acid.
DANGER! DO NOT attempt to dismantle the battery pack. For safety and environmental reasons DO
NOT discard in domestic waste or by burning. ONLY discard or recycle according to local waste
authority regulations.
WARNING! DO NOT allow a leaking battery to come into contact with your skin. If you come into contact
with battery fluid take immediate action:
a) Skin contact: Wash immediately with soap and water.
b) Eye contact: Flush eye immediately with cool, clean running water for at least 15 minutes and seek
immediate professional medical attention.
1
.2.
INTRODUCTION
Twin daylight fluorescent tubes suitable for applications where
mains power is unavailable. Tubes can be selected to run
individually or as a pair. Lantern can be powered from rechargeable
cells or from a mains supply cable - both stored integrally.
Electronic control allows lantern to be used as an emergency light,
switching on in the event of mains power failure. Lantern includes
carry handle and floor stand or can also be wall mounted.
3.
OPERATION
3.1.
CHARGING THE UNIT.
3.1.1 The unit will charge when plugged into mains supply regardless of either function or 'Power switch'
position.
However to achieve fastest charge put 'Power switch' in 'OFF' position and set 'Function switch' to '0'.
3.1.2 Open the power cable compartment at the back of the lantern. Uncoil the power cable and plug it into
the mains power supply. The red LED will light to indicate the presence of mains power.
3.1.3 The battery pack will take approximately 20 hours to charge initially. Subsequent charging times will
depend on the state of discharge of the battery pack.
3.1.4 When charging is complete unplug the mains power cable and stow it back in the compartment. You
may leave the cable connected if you wish to run the lantern from the mains supply.
3.2.
USING THE LANTERN ON mAINS POWER.
3.2.1 Slide the 'Power switch' to the 'ON' position.
3.2.2 Open the power cable compartment at the back of the lantern. Uncoil the power cable and plug it into
the mains power supply. The red LED will light to indicate the presence of mains power.
3.2.3 Select the required tube combination using the function switch. The 'Function switch' has three positions:-
1) 1 Tube
3.2.4 Should the mains power fail the unit will automatically revert to battery operation.
3.2.5 With mains connected; 'Power switch' in the 'OFF' position (lights OFF), the tubes will light in the event of
power failure providing one or two tubes are selected on the 'Function switch'.
3.3.
USING THE LANTERN ON BATTERY POWER.
3.3.1 The 'Power Source' switch may be in the 'ON' or 'OFF' position.
3.3.2 Select the required tube combination using the 'Function switch'. The 'Function switch' has three
positions:-
1) 1 Tube
3.3.3 After a full charge the lantern will run for approximately 1hr 45min on two tubes and 3hr 45min on one
tube.
NOTE! The green LED will light whenever a bulb should be lit. If the tubes DO NOT light and the green
LED is lit, suspect a faulty tube.
0) OFF
2) Both Tubes
0) OFF
2) Both Tubes
Tubes:
Tube Length:
Mains Supply:
Battery:
Operating Time:1 Tube:
Replacement Tube:
Original Language Version
2 x 18W
230V 50Hz 40mA
6V 4.5Ah
3hr 45min
2 Tubes:
1hr 45min
003-SD1824D
ML18/36.V2
Issue: 2 - 12/10/09
600mm
Advertisement
