EPH Controls R27-RF Installation Instructions

R27-RF - 2 Zone RF Programmer
CAUTION!
Installation and connection should only be carried out by a quali ed
person and in accordance with national wiring regulations.
Before commencing any work on the electrical connections, you must rst disconnect the programmer

from the mains. None of the 230V connections must be live until the installation has been completed and
the housing is closed. Only quali ed electricians or authorised service sta are permitted to open the
programmer. Disconnect from mains supply in the event of any damage to any buttons.
There are parts that carry mains voltage behind the cover. The programmer must not be left unsupervised

when open. (Prevent non specialists and especially children from gaining access to it.)
If the programmer is used in a way not speci ed by the manufacturer, its safety may be impaired.

Ensure that this wireless enabled programmer is installed 1 metre from any metalic object, television, radio

or wireless internet transmitter.
Prior to setting the programmer, it is neccessary to complete all required settings described in this section.

Never remove this product from the electrical baseplate. Do not use sharp tools to push any button.

This programmer can be mounted in the following ways: 1. Directly wall mounted 2. Mounted to a recessed conduit box
1
160.5
3
5
EPH Controls Ireland
technical@ephcontrols.com www.ephcontrols.com
Type
IP20
1C
EN60730 EN60529
50 122
°C
°F
0 32
5-95%RH
Page 1 of 2
Installation Instructions
For use in normal environments.
Important: Keep this document
This 2 zone RF programmer is designed to provide
ON/OFF control for 2 zones, with the value added
application of in built frost protection.
2
4
6
EPH Controls UK
technical@ephcontrols.co.uk www.ephcontrols.co.uk
20221107_R27-RF_InsIns_PK