Advertisement
Quick Links
wash-ONE & wash-TWO
Product
wash-ONE
wash-TWO
FS 619979
ISO 9001:2015
Operators Manual
Version1.0
Contents
2 .... Fitting the Handwash
8 .... Membrane Label
9 .... Operation
11 .... Health & Safety
Model Name
Voltage
ONE/12
12vdc
ONE/24
24vdc
TWO/12
12vdc
TWO/24
24vdc
Serial No:
E
11
E11*10R05/01*12293*00
wash-ONE & wash-TWO Operators Manual |
Capacity
4.0Ltrs
4.0Ltrs
7.5Ltrs
7.5Ltrs
APPROVED PRODUCT
1
Advertisement
Summary of Contents for TRANSVEND wash-ONE
- Page 1 & wash-TWO Operators Manual | wash-ONE & wash-TWO Operators Manual Version1.0 Contents 2 ..Fitting the Handwash 8 ..Membrane Label 9 ..Operation 11 ..Health & Safety Product Model Name Voltage Capacity wash-ONE ONE/12 12vdc 4.0Ltrs ONE/24 24vdc 4.0Ltrs...
- Page 2 & wash-TWO Operators Manual | Fitting the handwash Ensure that the handwash is fitted level and mounted in accordance with the instructions so that the tap/s cannot be accidentally operated or knocked. Mount the handwash in such a way to: - •...
- Page 3 N.T.S ISSUE DATE MOD BY Change Description .XXX = 0.005 B=Deleted This drawing is the property of Transvend Ltd. MATERIAL: FINISH: It must not be loaned, copied or re-produced Angular. wihtout the prior written consent from Transvend .X = 2...
- Page 4 & wash-TWO Operators Manual | • Place your handwash on the fixing bracket. Sliding the angled lip through the back panel. • Mark through the lower fixing holes – (shown here without a sink fitted). (Fixing holes shown here with a sink fitted).
- Page 5 & wash-TWO Operators Manual | (Fixing holes shown here with a sink fitted). Connecting the waste tube The waste tube is 25mm ID, 31mm OD , once connected over the adaptor piece make sure that the tube does not kink, this could cause damage and reduce the flow of waste water.
- Page 6 & wash-TWO Operators Manual | Connecting to the power & fuse IMPORTANT! Check your +ve and -ve supply cables are correctly labelled. The device has reverse polarity protection, but if you connect the power and reverse the polarity, then the device will not work.
- Page 7 & wash-TWO Operators Manual | Trigger wire If a trigger wire is fitted (see image below), it disables the ON/OFF button and controls the power to the handwash. DIP switch 5 (DIP5) on the hardware selects whether you’d like to operate the handwash with a trigger wire or the ON/OFF button.
- Page 8 & wash-TWO Operators Manual | Membrane switch label ON/OFF Button • Switches the handwash on and off, unless a trigger wire is fitted and has been activated to switch the product ON/OFF. Battery Warning LED • The ‘Battery Warning LED’ flashes to indicate if there’s a problem with the input voltage to the handwash.
- Page 9 • VS, Voltage Sensing – Controlled via DIP switch 2 (DIP2). Ĕ VS mode will only work when the handwash is switched on. Ĕ VS mode thresholds are defined in software – Please contact Transvend if you require the handwash to have specific voltage thresholds set.
- Page 10 & wash-TWO Operators Manual | • PH, Press to Heat (Single cycle heating) – Controlled via DIP switch 4 (DIP4) Ĕ NO trigger wire handwash. – PH mode activates ‘once only’ heating cycles. Once the handwash has reached the correct handwash temperature, the green ‘Ready LED’...
- Page 11 Ĕ ‘Alternator Sensing - AS’ DIP3 activated – *increase input voltage above AS threshold* Ĕ Please call Transvend if you’re unsure of your VS (Voltage Sensing - DIP2) or AS (Alternator Sensing - DIP3) thresholds • Heating LED – Red - 3 Flashes (then pause and repeat) Ĕ...
- Page 12 & wash-TWO Operators Manual | Dimensions wash-ONE – Including sink assembly 306mm 420mm 455mm 420mm 250mm 250mm Weights 3.8kg empty 7.8kg full (4.0 Ltrs water)
- Page 13 & wash-TWO Operators Manual | Dimensions wash-ONE – NO sink assembly 306mm 240mm 356mm 240mm Weights 2.85kg empty 6.85kg full (4.0 Ltrs water)
- Page 14 & wash-TWO Operators Manual | Dimensions wash-TWO – Including sink assembly 306mm 420mm 555mm 420mm 250mm Weights 4.7kg empty 250mm 12.2kg full (7.5 Ltrs water)
- Page 15 & wash-TWO Operators Manual | Dimensions wash-TWO – NO sink assembly 306mm 240mm 456mm 240mm Weights 3.75kg empty 11.25kg full (7.5 Ltrs water)
- Page 16 & wash-TWO Operators Manual | Transvend Ltd Unit 15, Amor Way Letchworth SG6 1UG United Kingdom +44 (0)1462 676035 info@transvend.com www.transvend.com...
Need help?
Do you have a question about the wash-ONE and is the answer not in the manual?
Questions and answers