GE DBXR453ET Owner's Manual page 10

Other dryer features your model has
10
Tools Needed:
• Standard # 2 Phillips screwdriver
• Tape-tipped putty knife
• Needle-nosedpliers
1 Open
the door and remove the
filler plugs opposite the hinges.
2 With the door completely open,
remove the bottom screw from
each hinge on the dryer face.
3 Insert these screws about half
way into the TOP holes, for each
hinge, on the opposite side.
(Where you removed the filler
plugs.) Apply firm pressure to get:
the screw started in untapped
holes.
4 Loosen the top screw from each
hinge on the dryer face halfway.
5 With
one hand holding the top
of the door and the other hand
holding the bottom, remove the
door from the dryer by lifting ii
UP and OUT.
6 Rotate the door 180 °. Insert it
on the opposite side of the open-
ing by raoving the door IN and
DOWN until the top hinge and
the bor:om hinge are resting on
the top screws inserted in step 3.
7 Remov,z the remaining screws
from the side of the opening
from which the door was
removed. With these screws
secure each hinge at the bottom.
8 Tighten the two top screws of
each hinge.
9 Reinsevt the plastic plugs on
the side from which the door
was removed.