LG W1S1CVK2EHM Owner's Manual page 49

• If the security protocol of the router is set to
WEP, network setup may fail. Change the
security protocol (WPA2 is recommended) and
connect the product again.
Using the Appliance Remotely
Remote Start
Use a smartphone to control your appliance
remotely. You can also monitor your cycle
operation so you know how much time is left in the
cycle.
Using this function
1
Put the clothes into the drum.
2
Press the Power button.
3
Press and hold Remote button for 3 seconds to
enable the remote control function.
4
Start a cycle from the LG ThinQ application on
your smartphone.
NOTE
• Once this function is enabled, you can only start
a cycle from the LG ThinQ smartphone
application. If the cycle is not started, the
appliance will wait to start the cycle until it is
turned off remotely from the application or this
function is disabled.
• If the door has been opened, you can not start a
cycle remotely.
Disable this function manually
When this function is activated, press and hold the
Remote button for 3 seconds.
Delay End
Setting this function allows the appliance to start
automatically and finish after a specified time.
SMART FUNCTIONS
Using this function
1
Put the clothes into the drum.
2
Press the Power button.
3
Run LG ThinQ application and select the
product.
• For washing, select the washer.
• For drying, select the dryer.
4
Select a washing or drying programme.
5
Touch the Delay End and set the delay time.
6
Start a cycle from the LG ThinQ application on
your smartphone.
NOTE
• The delay time is the time to the end of the
programme, not the start. The actual running
time may vary due to water temperature, clothes
and other factors.
• Avoid using liquid detergent for this function.
Open Source Software Notice
Information
To obtain the source code that is contained in this
product, under GPL, LGPL, MPL, and other open
source licenses that have the obligation to disclose
source code, and to access all referred license
terms, copyright notices and other relevant
documents, please visit https://
opensource.lge.com.
LG Electronics will also provide open source code to
you on CD-ROM for a charge covering the cost of
performing such distribution (such as the cost of
media, shipping, and handling) upon email request
to opensource@lge.com.
49