Panasonic CT-27D20 Operating Instructions Manual page 6

Installation
Installation
Television Location
This unit is intended to be used with an optional stand or entertainment center.
Consult your dealer tor available options.
□
Avoid excessive sunlight or bright lights, including reflections.
□
Keep away from excessive heat or moisture. Inadequate ventilation may cause internal
component failure.
n Fluorescent lighting may reduce remote control transmitting range.
□
Keep away from magnetic equipment, including motors, fans and external speakers.
Optional Cable Connections
Shielded audio and video cables should be used between components. For best
results:
□
Use 75-ohm coaxial shielded cables.
□
Use appropriate input and output connectors, that match your component connectors.
□
Avoid long cables to minimize interference.
AC Power Supply Cord
CAUTION: TO PREVENT ELECTRIC SHOCK MATCH WIDE BLADE OF PLUG TO
WIDE SLOT OF AC OUTLET AND FULLY INSERT. DO NOT USE A PLUG WITH A
RECEPTACLE OR OTHER OUTLET UNLESS THE BLADE CAN BE FULLY
INSERTED TO PREVENT BLADE EXPOSURE, FOR SOME MODELS THAT ARE
NON-POLARIZED, THE USE OF AN AC ADAPTOR CONNECTOR MAY
BE NECESSARY.
Nori'Polarized plug
Cable / Antenna Connection
For proper reception, either a cable or antenna connection is required.
Cable Connection
Connect the cabje supplied by your local cable company.
Note: A cable converter box may be required for proper reception. Check with
your local cable company for compatibility requirements.
n
Antenna Connections
□
For proper reception of VHF/UHF channels, an external antenna is
required. For best reception an outdoor antenna Is recommended,
n Antenna Mode must be set to TV.
V 'V
Cable Preset
Cable Mode is preset at the factory. Antenna
users must change to Antenna Mode in the
Setup Menu,
Incoming Cable from
Cable Company
75 Ohm VHF/UHF
on back of TV
Incoming Cable from
Home Antenna