Table of Contents
Advertisement
ASSEMBLY DIRECTIONS
ILLUSTRATION A
Slide the
short
silver
colored
rod
into the
long silver colored rod, the end
with the four
sets of holes. The snap locks
on
the short
rod
will later
be used
to
set desired length.
ILLUSTRATION 3
Remove
the two plastic washers, bolt
and
thumbnut. Connect
the
loop to the short
plastic
rod by
placing the two plastic washers
in
the depressions
on
the
rod. Next,
line the holes
on
the loop bracket with the holes
on
the
rod.
insert the bolt
and
thumbnut. tightening
by hand.
CAUTION: Do
not
over
tighten the waterproof cable
fitting
on
the loop!
ILLUSTRATION
C
Connect the short
plastic
rod
with the attached loop to the
Joined
sliver colored rods.
ILLUSTRATION
D
Slide the completed rod sections Into the bracket underneath the Instrument control
box.
Advertisement
Table of Contents
