Summary of Contents for Beretta IDRA BV 200
- Page 1 Installation and Operation Manual IDRA BV 200-1000 Storage cylinder Installation and Operation Manual...
-
Page 2: Table Of Contents
GENERAL INFORMATION RANGE The following symbols are used in this manual: MODEL CODE Identifies actions that require caution CAUTION! = IDRA BV 200 20101895 and adequate preparation. IDRA BV 300 20101897 IDRA BV 430 20101899 Identifies actions that you MUST NOT do. -
Page 3: Precautions
Never attempt to install the system without using suit- of the product. able personal protection equipment and without fol- lowing all applicable occupational safety standards. Beretta Caldaie Via Risorgimento, 23/A Do not touch the product when barefoot or wet if it 23900 Lecco (LC) -
Page 4: Structure, Dimensions And Fittings
GENERAL INFORMATION STRUCTURE, DIMENSIONS AND FITTINGS (SB) Magnesium anode Plug for anode inspection and lifting Temperature gauge Plug for inspecting the second anode Storage cylinder Coil Storage cylinder THERMOSTAT SENSOR or storage Adjustable foot cylinder TEMPERATURE SENSOR Insulation Guide Cover IDRA BV DESCRIPTION 1000... -
Page 5: Technical Specifications
GENERAL INFORMATION TECHNICAL SPECIFICATIONS IDRA BV DESCRIPTION 1000 Type of storage cylinder Vitrified Storage cylinder layout Vertical Heat exchanger layout Vertical Storage cylinder capacity Diameter of storage cylinder with insulation 1000 Diameter of storage cylinder without insulation Height with insulation 1335 1835 1645... -
Page 6: Installation
INSTALLATION ASSEMBLY OF THE INSULATION PLACE OF INSTALLATION AND THE LINING storage cylinders can be installed in any IDRA BV room where there is no specific requirement for an electri- 800 - 1000 IDRA BV cal protection rating higher than IP X0D. The assembly of the insulation and lining components must be performed at the site of installation to facilitate passage through any doors and/or entries to the room. -
Page 7: Technical Assistance Centre
TECHNICAL ASSISTANCE CENTRE MAINTENANCE MODELS IDRA BV 800 - 1000 Removing and checking the second magnesium anode - Remove the plug (5) and use a suitable wrench to Perform the following operations before beginning any unscrew the anode holder (6). maintenance: - Check the magnesium anode for wear and replace it - Switch the electricity supply to the storage cylinder’s... - Page 8 Via Risorgimento, 23 A 23900 - Lecco (LC) www.berettaboilers.com The manufacturer strives to continuously improve all products. Appearance, dimensions, technical specifications, standard equipment and accessories are therefore liable to modification without notice.
Need help?
Do you have a question about the IDRA BV 200 and is the answer not in the manual?
Questions and answers