Table of Contents
Advertisement
KT-1950
|
®
For earphone listening, simply plug the earphone into
@
When
the
[< PLAY]
button
is pressed, the
[REC
the [EAR] jack.
To stop the tape
temporarily
Review function
[P>PREVIEW REW]
Cue function
[44 CUE FF]
BATT]
indicator lamp will light up.
During playback mode, press the [>> REVIEW
REW]
button.
The tape will be rewound only
while the button is depressed.
When the button is released, the tape will resume the former
play back mode.
Operation is much the same as the review function.
Press the [<«¢ CUE
FF]
button during
playback mode, and release again when the desired section of tape has been located.
The tape
will then resume playback mode.
Recording With the Built-in Microphone
5 To stop recording, press the
tk
as a
[ = 4STOP/OPEN]
button.
3. Press the [ @ REC] and
[<« PLAY]
buttons together.
Proceed according to the numbered steps.
1. Open the cassette compartment,
and insert a cassette
Figure 6
4. Speak
into
the
built-in
microphone.
To
monitor
what
is being
recorded,
plug an earphone
into the
[EAR] jack.
@ The
[REC/BATT]
indicator lamp will turn on and
® The KT-1950 has been equipped with an automatic
off according to the volume
level of the recorded
recording level control circuit (ALC) that will auto-
source, thereby indicating that recording is in progress.
matically adjust recording to a suitable level.
Note that it will not be possible to press the [ ® REC]
button if the erasure prevention tabs along the back ridge of the
cassette tape have been broken off. Do not apply undue pressure to this button in this case.
ASO (Auto Shut Off)
Erasure of recorded tapes
Set the Input Selector to the External Input position. Then simultaneously press the [@ REC]
and
[ « PLAY]
buttons
to commence
recording mode.
The pre-recorded material will be
erased.
Note, however, that this must be done in a relatively quiet place.
Any loud noises
nearby will be recorded.
2. Reset the tape counter to *'000".
ww
Advertisement
Table of Contents
