Advertisement
@ Hold Switch
lf you slide the switch to the direction of the arrow (
) after
the set has been turned off by pressing the Power Off Button, the
set will not be turned on even if the Band Select Buttons are pressed
by mistake. This prevents the batteries from being wasted.
It is useful when carrying the set. Especially before putting the set
into the carrying case, be sure to slide the switch to the direction of
the arrow ( HEC» ).
When listening to the radio, if you slide the switch to the direction of
the arrow (
), the other Band
Select
Buttons and the
Power Off Button do not operate.
So you can avoid changing the
received band or turning the set off by mistake.
B Antennas
Caution when adjusting the Telescopic Antenna
elf you wish to adjust the Telescopic Antenna,
pull the base of the antenna until you hear a
click, and then pull the remaining sections to
extend it fully. If this unit is positioned horizon-
tally and used, you will not be able to adjust
the antenna unless the base has been pulled
free of the set.
When
folding up the antenna, first push the
base back into the set and then push the
antenna elements back together starting with
the thicker ones.
(D)
nl!
(C)
(B)
Fig. 1
RF-B20L
aie 740)
FM:
Pull out the Telescopic Antenna and adjust its length and angle for
optimum
reception.
MW/LW:
The sensitive ferrite core antenna inside the set will provide excellent
MW/LW reception in most areas. For optimum reception, turn the set
in the direction which gives the best results since the ferrite core
antenna is directional.
Swi-6:
Extend the Telescopic Antenna fully, keep it vertical.
FM
MW/LW
SW1-6
@ Listening with the Earphone
Plug the supplied earphone into the Earphone Jack. The Speaker in
the radio is automatically disconnected when the plug is inserted.
eAdjust the volume to lower level so as not to injure your ear.
(F)
Fig. 4
(G) (H) (G)
Fig. 5
Front Cabinet
Fig. 7
Pet
8
|
Front Cabinet
LED Circuit Board
Main Circuit Board
«x1. Remove SW1~6 Band Switch Knob by removing 3 ribs of the chassis as shown in Fig. 6. At this time, be careful not to loose the steel
ball and the spring.
Advertisement
