Precision AM60 Installation Manual

Precisi n
AM 6 O
MAGNETIC TUBULAR LATCH
1
1
1. Edgebore-Drill a Ø25mm hole into the edge of the door at
the desired height.
Crossbore-Drill hole(s) into the face of the door at a backset of
60mm to the diameter(s) etc specified on the chosen handles
installation instructions.
4
4. Insert the Strikebox/Drilling Template into the flanged
S/Steel Housing Cup (to allow easy removal of
Strikebox/Drilling Template from drilled Ø25mm holes), then
insert Strikeplate/Housing Cup assembly into the door's
Ø25mm edgebore hole and use as a guide to drill 2x Ø3mm
pilot holes (through the Pilot Hole Alignment
below edgebore hole.
Repeat this step on the Ø25mm hole drilled into door jamb
INSTALLATION
S/steel housing cups
Strikebox/drilling template Strikebox/drilling template
Self Adhesive Self Adhesive
coverplates coverplates
Strikeplate Strikeplate
B B
Pilot Hole Alignment Disc(s) Pilot Hole Alignment Disc(s)
2
Edgebore
o
24mm
Edgebore
o
25mm
2. Insert the
(2A).
Close door tightly then press the pointed Strikemarker tool
into the jamb to mark a mounting position for the strikeplate.
5
5. Use the Ø3mm pilot holes in door as a guide to drill
2 x Ø25mm overlapping holes (above and below the
Ø25mm hole) to a depth of approx. 4mm.
Discs) above and
Repeat this step on the jamb to create 2x Ø25mm overlapping
holes.
GUIDE
60mm
C C
A A
2a
Strikemarker tool (FIG.B) into the edgebore hole
edgebore
Precisi n
A M 6 O P V
TUBULAR PRIVACY BOLT
20mm 20mm
8x8mm 8x8mm
3
3. Drill a Ø3mm pilot hole into the jamb at the position
marked by the pointed Strikemarker tool.
Use the pilot hole as a guide to drill a Ø25mm hole into
the jamb to a depth of approx. 20mm
6
6. Use a blade or pencil to mark vertical lines down the sides
o
of the 3x overlapping Ø25mm holes on door and
jamb (6a).
Use a Chisel to remove timber from the sides of the
o
overlapping Ø25mm holes where marked.
3a
(3a).
6a