GENMAX GMEFP User & Installation Manual

(GMEFP) FUEL PUMP USER USE INSTALLATION MANUAL
Recommended Models: GM2000i, GM2200i, GM2800i, GM3500i, GM4600i series

Accessories

Green Light Switch
Red Light
12V DC Power Supply
Control Panel
12V DC Power Cable
Applicable Fuel Tank
Capacity (Generator) :
2.5L-10L

Connecting Fuel Tank

(The fuel tank needs to be purchased separately.)
1
Connect the fuel hose to the tank.
Fuel Hose
Fuel and its vapors are extremely flammable and explosive which
could cause burns, fire or explosion resulting in death or serious
injury.
• Fill or drain fuel tank outdoors.
• DO NOT overfill tank. Allow space for fuel expansion.
• If fuel spills, wait until it evaporates before starting engine.
• Keep fuel away from sparks, open flames, pilot lights, heat, and other ignition
sources.
• Check fuel lines, tank, cap and fittings frequently for cracks or leaks. Replace
if necessary.
• DO NOT light a cigarette or smoke.

Fuel Pump Use Steps

1. Tighten the fuel pump to the fuel tank port of the generator.
2. Use a fuel hose to connect the external fuel tank to the fuel pump.
3. Connect the 12V DC power cable to the 12V DC power plug, and then connect to the fuel pump.
4. Start the generator and insert the 12V DC power plug into the 12V DC socket of the generator when the motor is stable.
Sensor
2
Fill with gasoline.

WARNING

Fuel Pump
Fuel Intake Port
12V DC Power Plug (clip)
0.18inch
12V DC Power Plug
Thread Size
1.95inch
2.19inch
3 Turn the tank cap ventilation knob to
"ON" before using the generator.

ATTENTION

If the tank is
filled with
gasoline, rotate
the tank 90°
before
connecting the
hose.
Fuel Hose
90°