Table of Contents
Advertisement
When the file is open in Trans comment code is Green, state sets are indicated in Blue, and
C.
standard code is in Black.
D.
Translate and Compile - use the "Translation" menu to choose "Make" singly as needed, or
"Batch Translate!" to convert all the protocols open. You can also run these options from the
Batch Translation window (open from the "Window" menu). Compilation Errors can be reviewed
in the Results window (open from the "Window" menu).
VIII. Start MED-PC and review/select the desired options for saving data files by clicking (Data | File
Options...).
TABLE 5.1 MINIMUM INSTALLATION AND SYSTEM REQUIREMENTS FOR MEDTEST & MED-PC 6
Operating System
Processor, Graphics
Display and RAM
Hard Disk Space
Hardware
SAMPLE MED-PC PROGRAMS
Refer to the DOC-335 Med-PC 6 User's Manual and DOC-301 Med-PC Programmer's Manual for detailed
information.
If the installation media that came with the OmniCtrl system has been installed on the computer, example
MedState Notation code examples can be found at:
Procedures and Parameters for Med-PC
For parameters needed to control OmniSound Devices Reference DOC-336 OmniSound User's Manual.
For a complete reference of syntax see DOC-301 Med-PC Programmer's Manual. Table 5.2 Med-PC Procedures
lists some stand out commands added to MedState Notation for Med-PC 6.
For IC-124 cards with a DIG-705 only; using these functions on an older card will have no effect.
They can therefore be used with older systems set manually with DIP-switches without issue.
TABLE 5.2 MED-PC PROCEDURES
COMMAND
Usage
Description
Parameters
Example
RECOMMENDED MINIMUM RQUIREMENT
Windows 10 64 bit or later
Minimum to run OS
>600 MB (approximate Installation size for Med-PC Med Test and Med Drivers)
USB 2.0 or faster serial port
INPUTSTOLEVEL
INPUT: INPUTSTOLEVEL P1, P2, ..., Pn ---> NEXT
When MED-PC is started or when a program is finished running in a Box, all inputs that
were assigned to that Box with the Hardware Configuration Utility are set back to the
default setting of Toggle Mode. If a program needs an input to be in Level Mode, then
that program must use the INPUTSTOLEVEL command.
P
, P
, P
Where n is a port number that has been declared in the Hardware
1
2
n
Configuration Utility and that the current program is using.
S.S.1,
S1,
0.01": INPUTSTOLEVEL 1,2,3,4,5,6,7,8 --->
C:\MED-PC\MPC\
SOFTWARE| 25
S2
Advertisement
Table of Contents
