Mitsumi Z-Wave FGT-0003 User Manual

Smart lock

Hide thumbs

Table Of Contents

Table of Contents

Quick Links

Download this manual

Z-Wave™ Smart Lock

FGT-0003

User's Guide

Rev. 1.02

MITSUMI ELECTRIC CO., LTD.

Table of Contents

Need help?

Do you have a question about the Z-Wave FGT-0003 and is the answer not in the manual?

Questions and answers

Summary of Contents for Mitsumi Z-Wave FGT-0003

Page 1 Z-Wave™ Smart Lock FGT-0003 User’s Guide Rev. 1.02 MITSUMI ELECTRIC CO., LTD.
Page 2 Introduction This product is an electronic door lock "FGT-0003" that supports Z-Wave Plus™ as standard. This is attached to the thumb turn and unlocked / locked using the controller. This product is a security enables Z-Wave Plus product that is able to use encrypted Z-Wave Plus messages to communicate to other security enabled Z-Wave Plus products.
Page 3 ■Installation by Operation SW ◇Preparation of this product 1. Grasp both sides of the machine and slide the top cover upward to remove it. Move the knob in the direction of the arrow labeled "BATTERY RELEASE" to remove the battery holder. Insert four CR123A batteries.
Page 4 ◇Unlocking position setting Turn the thumb turn knob of this unit to the unlocked position. Press and release the operation switch on the left side of the lock body with a thin stick for 5 seconds or longer. The LED will red once and beep twice. After that, the LED will blink light blue. ◇Locking position setting Turn the thumb turn knob of this unit to the locked position.
Page 5 Z-Wave Overview Z-Wave+ Product Info ・Manufacturer: MITSUMI ・Z-Wave Device Type: Door Lock Keypad ・Z-Wave Role Type: Listening Sleeping Slave (LSS) ・Product ID: 0x0001 ・Product Type ID: 0x0011 Supported Command Classes Command Class List (Security: None) ・COMMAND_CLASS_ZWAVEPLUS_INFO ・COMMAND_CLASS_TRANSPORT_SERVICE ・COMMAND_CLASS_SECURITY ・COMMAND_CLASS_SECURITY_2 ・COMMAND_CLASS_SUPERVISION Command Class List (Security: S2) ・COMMAND_CLASS_ASSOCIATION...
Page 6 BASIC Basic Set is used to lock and unlock this product. See table to see how the Door Lock Mode parameter affects the lock. Unlock Lock Value 0x00 0xFF This product reports the Lock status with Basic Report. Unlock Lock Unknown Current Value 0x00...
Page 7 MANUFACTURER SPECIFIC Upon receiving a Manufacturer Specific Get request, it returns a Manufacturer Specific Report Value Comment Manufacturer ID 0x0112 MITSUMI Product Type ID 0x0011 FGT Lock Series Product ID 0x0001 Lock Vol.1 POWERLEVEL Can be used under inclusion to test signal strength from the controller and to the device.