Page 1
75-75125 450DX 25HP VANGUARD GAS (S/N 0000 and higher)
Page 2
Your safe use of this Schiller Grounds Care, Inc. product is one of our prime design objectives. Many safety features are built in, but we also rely on your good sense and care to achieve accident-free operation.
Schiller of hazard seriousness. These words appear in this Grounds Care, Inc. Engineering Department. Any manual and on the safety labels attached to Schiller Schiller Grounds Care, Inc. product that is altered, Grounds Care, Inc. machines. For your safety and...
Page 5
SAFETY STEINER 450 DX Operator preparation and training Site preparation and circumstances Read the Operation & Safety Manual – Evaluate the terrain to determine what – If an operator or mechanic cannot read English accessories and attachments are needed to or one of the other languages in which this properly and safely perform the job.
Page 6
SAFETY STEINER 450 DX OPERATING SAFETY Starting – Start only according to instructions in this manual In general or on the machine. – Use extra care when loading or unloading the machine into a trailer or truck. – Before attempting to start the engine, make sure: - the parking brake is on;...
Page 7
SAFETY STEINER 450 DX Interrupting operation Rollover Protection Structure (ROPS) – Before leaving the operator's position: - Park on level ground. - Lower attachments. – A Rollover Protection Structure (ROPS) for this - Disengage the PTO. tractor is standard. Seat belts must be worn - Set the parking brake.
Page 8
SAFETY STEINER 450 DX Operating on slopes – Slopes are a major factor in loss-of-control and – Use caution when operating near drop-offs, tip over accidents that sometimes lead to severe ditches or embankments. The machine could injury or death. suddenly turn over if a wheel runs over the edge or an edge caves in.
Page 9
SAFETY STEINER 450 DX MAINTENANCE SAFETY explosions. Flowing fuel can generate static electricity. To prevent static electricity sparks: I n general – Do not fill containers in a vehicle or on a truck or – Maintain machine according to manufacturer's trailer bed with a plastic liner.
Page 10
SAFETY STEINER 450 DX Battery JUMP STARTING WARNING Battery acid is caustic and fumes 1. Be sure the jumper cables are in good condition. are explosive and can cause Turn off the ignition and all electrical accessories serious injury or death. on both machines.
LABELS STEINER 450 DX WARNING BEFORE STARTING: - READ AND UNDERSTAND OPERATOR MANUAL AND LABELS. - WEAR HEARING AND EYE PROTECTION. - REPLACE LABELS AND OPERATOR MANUAL IF LOST OR DAMAGED WARNING AVOID SERIOUS INJURY OR DEATH: - DO NOT OPERATE UNLESS TRAINED. - DO NOT OPERATE UNLESS GUARDS, SHIELDS, AND INTERLOCKS ARE IN PLACE AND WORKING.
Page 12
LABELS STEINER 450 DX WARNING MACHINE CAN TIP OR LOSE TRACTION ON SLOPES - USE REAR WEIGHTS WITH ATTACHMENTS - SEE ATTACHMENT MANUAL FOR CORRECT NUMBER OF WEIGHTS. - REMOVE WEIGHTS WHEN FRONT ATTACHMENTS ARE REMOVED. 4163040 4163040 FRONT OF PUMP COVER - ROTATING PARTS.
Page 13
LABELS STEINER 450 DX AUXILIARY FRONT LIFT F L O A T D O W N H O L D 4173965 4173965 TOP FRONT OF BATTERY COMPARTMENT TOP OF RELAY BLOCK COVER TOP OF FUSE BLOCK COVER 4177169 450 AC FUSE 4177170 450 AC RELAY 75-75125 4177169...
ASSEMBLY STEINER 450 DX The Steiner 450DX is designed for the commercial user or homeowner. From the rugged industrial frame to the operator controls the tractor is ready for demanding turf and grounds care applications. Power steering and articulated frame, combined with a low center of gravity and high flotation tires, provide ex- ceptional maneuverability.
Page 16
CONTROLS STEINER 450 DX 1. PTO ELECTRIC CLUTCH SWITCH - The PTO switch controls the front drive belt (Power Take Off or PTO) that supplies power to attachments. Pull the switch out to engage the PTO and start an attachment. Push the switch in to disengage the PTO and stop the attachment.
CONTROLS STEINER 450 DX 9. AUXILIARY HYDRAULIC LEVER Controls flow of hydraulic oil to hydraulic device connected to auxiliary hydraulic couplers. This allows extension or retraction of a hydraulic cylinder, or rotation of a hydraulic motor. There are four positions; HOLD, RAISE, LOWER, and FLOAT. Moving the lever forward from the hold positions lowers the attachment, moving it farther forward locks the lever into the detented FLOAT position that...
Page 18
CONTROLS STEINER 450 DX 13. FRONT HITCH RELEASE LEVER Rotate up and back to unlatch quick hitch to allow disconnecting attachment from tractor. Rotate forward and down to latch the attachment to the tractor. 14. PARKING BRAKE LEVER (On right side) Pull lever to engage parking brake.
OPERATION STEINER 450 DX FUELING: See Specifications Page 14 for fuel BEFORE STARTING THE ENGINE type and warnings. – Use a funnel to avoid spillage. – READ SAFETY DECALS. – Be familiar with all controls, how each functions and what each operates. NEVER FILL FUEL TANK WITH THE ENGINE –...
Page 21
OPERATION STEINER 450 DX OPERATING NOTES FUSES & RELAYS All electrical fuses (A) and relays (B) are locating in – OBSERVE SAFETY DECALS. covered housings behind the dash. Turn the battery disconnect to the off positions before replacing fuses – Practice at slow engine and travel speeds with the or relays.
Page 22
OPERATION STEINER 450 DX DRIVING 1. Select desired engine speed with the throttle. For power driven attachments, the engine is normally When the Neutral Bypass Selector Valve is open run at maximum RPM. and the parking brake is disengaged, the tractor can freewheel.
Page 23
OPERATION STEINER 450 DX - When operating on slopes be mindful of the OPERATION ON SLOPES possibility of changing conditions that could – Operation on slopes should only be attempted by impact safe operation and decrease the machines experienced operators. An experienced operator capability to navigate and manage slopes.
Page 24
OPERATION STEINER 450 DX PTO BELT DRIVE A belt drive is provided for power transfer to attachments. DO NOT ENGAGE THE PTO CLUTCH WITH THE ENGINE AT FULL THROTTLE ALWAYS REDUCE ENGINE RPM BEFORE ENGAGING PTO. STARTING HEAVY LOADS AT FULL THROTTLE WILL SHORTEN CLUTCH AND BELT LIFE Figure 1...
SERVICE CHARTS STEINER 450 DX EVERY EVERY EVERY EVERY SERVICE CHART DAILY HOURS HOURS HOURS HOURS Read safety decals. Check fuel level. Check engine oil level. Visual inspection of: Bolts and fittings for signs of loosening. Accumulation of dirt or foreign matter around engine, restricting engine cooling. Oil leaks or hydraulic hoses, belts, electrical wiring, showing signs of wear.
2. Turn the PTO on. This check should kill the engine after 1/2 second. Repair machine before using if the Operator Presence Interlock System does not operate correctly in start or run. Contact your authorized Schiller Grounds Care, Inc. dealer. HARDWARE Tighten any nuts and bolts found loose.
Page 27
MAINTENANCE STEINER 450 DX ENGINE To prevent accidental startups during maintenance or repair disconnect the battery. NOTE: THE USE OF ANY ENGINE OIL FILTER OTHER THAN THOSE SPECIFIED BY THE ENGINE MANUFACTURER IS NOT RECOMMENDED. IF AN AFTER MARKET PART CAUSES OR SUBSTANTIALLY CONTRIBUTES TO A FAILURE, THAT FAILURE MAY NOT BE COVERED BY WARRANTY.
Page 28
MAINTENANCE STEINER 450 DX COOLING HYDRAULIC SYSTEM – Allow muffler, engine cylinder and fins to cool NOTE: before touching. THE USE OF ANY OIL OTHER THAN STEINER – Remove accumulated debris from muffler area TRANS-HYDRAULIC OIL (BENZOIL THL303 and cylinder area. TRACTOR HYDRAULIC FLUID) IS NOT RECOMMENDED.
Page 29
15. Fill the rear transaxle through the fill tube with system. Improper hoses can cause injury. approximately 6 quarts of oil. NOTE: You may See your Schiller Grounds Care, Inc. dealer need to fill the tank multiple times and allow to for quality service parts and service of the drain.
Page 30
MAINTENANCE STEINER 450 DX ELECTRICAL SYSTEM FRAME 1. Check for loose or missing fasteners after first 10 - Do not bypass or eliminate safety devices. hours. - Every 100 hours thereafter. - Keep all electrical connections clean and dry. - Torque transaxle mount bolts 60 - 90 ft. lbs. - Do not add extra electrical equipment.
Page 31
ADJUSTMENTS STEINER 450 DX PROPER BELT TENSION IS VERY IMPORTANT The proper tension setting is obtained by moving the belt tension adjustment lever D until the resistance of the belt is felt, then go one notch further. If the drive belt slips during operation tighten one additional notch.
Page 32
ADJUSTMENTS STEINER 450 DX PARKING BRAKE ADJUSTMENT The parking brake is a dry disc type located on the front transaxle. As the friction pads wear it may be necessary to adjust the brake. NOTE: Check brake disc periodically to ensure it will float on the brake shaft.
Page 33
ADJUSTMENTS STEINER 450 DX THROTTLE ADJUSTMENT 1. Push throttle lever all the way forward stopping short of having the throttle wide open. 2. Push on throttle control bracket E to compress throttle control spring F. 3. Tighten bolt G. 4. Release throttle control bracket back to initial resting state.
TROUBLESHOOTING STEINER 450 DX SYMPTOM POSSIBLE CAUSE REMEDY Parking brake not set. Set parking brake. PTO engaged. Disengage PTO. Battery dead. Check battery, charge or replace. Defective wiring, broken or loose Visually check, or check with test light for continuity Engine will not turn connections.
Page 57
FRONT AXLE ASSEMBLY & WHEELS STEINER 450DX FIGURE 11 ITEM PART NO. DESCRIPTION ITEM PART NO. DESCRIPTION 4176572 TRANSAXLE - SINGLE SPEED 4166910-01 FITTING-SWIVEL RUN TEE/ 4166892 O-RING-3.25 X 3.375 X .062 51-023 PINION GEAR FOR 220 778155 25-2503-6-6 FITTING 90-6 MORB X -6MIJC 11-017 CLAMP-SMALL HOSE 108094-02...
Page 58
FRONT AXLE SUPPORT ASSEMBLY STEINER 450DX FIGURE 12...
Page 59
FRONT AXLE SUPPORT ASSEMBLY STEINER 450DX FIGURE 12 ITEM PART NO. DESCRIPTION ITEM PART NO. DESCRIPTION 4169830.17 PLATE-MTG, STEERING CYL 4172019.7 WLDMT-LOWER AXLE SUPPORT 25-2503-6-6 FITTING 90 -6 M ORB X -6 M JIC 64229-06 NUT-NYLON LOCK 5/8-11 64123-212 BOLT - 5/8-11 X 6.00 4172025.7 WLDMT-CENTER LINK INCLUDES ITEM 10 &...
DECALS STEINER 450DX FIGURE 21 75-75125 4177169 4177170 75-75125 STARTER ENGINE RELAY RELAY ENG & FUEL PUMP LIGHTS LIGHTS & ACC SAFETY SHUTOFF ACCESSORY RELAY RELAY RELAY COOLING FAN NOT USED IGNITION STARTER...
Page 77
DECALS STEINER 450DX FIGURE 21 ITEM PART NO. DESCRIPTION ITEM PART NO. DESCRIPTION 4177170 DECAL-45DX RELAY 4177169 DECAL-450DX FUSE 4176563 DECAL-450DX HOOD LEFT 4176564 DECAL-450DX HOOD RIGHT 4173920 DECAL-450 SIDE PANEL RIGHT 4173919 DECAL-450 SIDE PANEL LEFT 4176565 DECAL-450DX FUEL TANK 4176566 DECAL-450DX BATT COMP 4167336...
Page 78
DECALS STEINER 450DX FIGURE 22 WARNING TO CHECK OR ADD FUEL -Do it outdoors. -Stop engine. Allow to cool. BEFORE STARTING: -Do not smoke. - READ AND UNDERSTAND OPERATOR MANUAL AND LABELS. -Clean up spilled fuel. - WEAR HEARING AND EYE PROTECTION. -Do not overfill.
Need help?
Do you have a question about the STEINER 75-75125 and is the answer not in the manual?
Questions and answers