Table of Contents
Advertisement
E - OPERATOR MANUAL
DESCRIPTION OF EMITTER CONTROLS
Gas test
RTA increase (*):
- slow if the remote control is not placed on
its support.
- slow and fast if the remote control is placed on
its support.
Wire lifting
Axis 1 feed (*)
HF test
RTA decrease (*)
- slow if the remote control is not placed on
its support.
- slow and fast if the remote control is placed on
its support.
Wire feed
Axis 1 back (*)
Axis 2 feed (*)
Axis 3 feed (*)
Seam tracking left
Seam tracking right
Axis 2 back (*)
Axis 3 back (*)
Cycle start (*)
Cycle stop
(*): The out of cycle function is active only if the remote control is placed on its support.
-16
Out of cycle
In cycle
Intensity incrementing
Voltage incrementing
Wire speed incrementing
Welding speed incrementing
Intensity decrementing
Voltage decrementing
Wire feed decrementing
Welding speed decrementing
Plasma gas rate incrementing
-
Seam tracking left
Seam tracking right
Plasma gas rate decrementing
-
Cycle start
Cycle stop
RADIO CONTROL
8695 5571 / C
Advertisement
Table of Contents
