Advertisement
For West Germany
Bescheinigung des Herstellers/Importeurs
Hiermit wird bescheinigt, daB der/die/das
in Ubereinstimmung mit den Bestimmungen der
Roland DIGITAL NOISE ELIMINATOR SN-550__
Amtsbl. Vig 1046/1984 _
(Geral. Typ. Bazaicbiuia)
(Amtsblattverfugung}
funk-entstort ist.
Der Deutschen Bundespost wurde das Inverkehrbringen dieses Gerates angezeigt und die Berechtigung zur Uberpriitung
der Serie auf Einhaltung der Bestimmungen eingeraumt.
Roland Corporation Osaka/Japan
Name des Herstellers/!mporteurs
For the USA
RADIO AND TELEVISION INTERFERENCE
WARNING —
— This equipment has been verified to comply with the limits tor a Class B computing device, pursuant to Subpart J, of Part 15. of FCC rules. Operation with
non-certiied or non-verified equipment ts likely to result in interference to radio and TV reception
The equipment descnbed in this manual generates and uses tadio frequency energy 1{ it is nol installed and used properly. that is. in strict accordance with our instructions.
it may cause interference with radio and television reception. This equipment has been tested and found to comply with the limits for a Class B computing deuice in accordance
with the specifications in Subpart J, of Part 15, of FCC Rutes. These rules are designed to provide reasonable protection against such a interference in a rasidential installation.
However, there 1s no guarantee that the interference will nat occur in a particular installation. If this equipment does cause interference to radio or television reception, which
can be determined by turning the equipment on and off, the user is encouraged to try to correct the interference by the following measure
© Disconnect other devices and their input/output cables one at a time. If the interference stops. it is caused by either the other device or its /O cable.
These devices usually require Roland designated shielded \/O cables. For Roland devices, you can obtain the proper shielded cable from your dealer. For non Roland
devices, contact the manufacturer or dealer for assistance.
tf your equipment does cause interference to radio or television reception, you can try to correct the interference by using one ot more of the following measures.
Turn the TV of radio antenna until the interference stops.
Move the equipment to one side or the other of the TV or radio.
Move the equipment farther away from the TV or radio.
Plug the equipment into an outlet that is on a different circuit than the TV or radio. (That is, make certain the equipment and the radio or television Set are on circuits con-
trolled by different circuit breakers or fuses.)
Consider installing a rooftop television antenna with coaxial cable lead-in between the antenna and TV. If necessary. you should consult your dealer or an expenenced
radio/television technician for additional suggestions. You may find helpful the following booklet prepared by the Federal Communications Commissian:
"How to Identify and Resolve Radio — TV interference Problems"
This booklet is available fram the U.S. Government Printing Office, Washington, D.C.. 20402, Stock No. 004-000-00345-4.
For Canada
CLASS B
NOTICE
This digital apparatus does not exceed the Class B limits for radio noise emissions set out in the Radio Interference
Regulations of the Canadian Department of Communications.
Senaeee |
CLASSE B
AVIS
|
Cet appareil numérique ne dépasse pas les limites de la classe B au niveau des émissions de bruits radioélectriques fixes
dans le Réglement des signaux parasites par le ministere canadien des Communications.
1
Advertisement
