Page 1
EPA Est. No.98547-TWN-1 IMMERSION UV-C Before using Immersion UV-C, please make sure that the quartz sleeve is not broken and all connectors / fittings are tightened. Once leaking is found, please stop using it in case of any accident. Disconnect the power supply before any cleaning or maintenance, and do not pull the UV lamp up with the power cable.
Page 2
• Before using Immersion UV-C, please make sure that the quartz sleeve and UV lamp are not broken. • Use a clean soft cloth or gloves to handle the UV lamp and the quartz sleeve. NOTICE • Do not cut / manipulate / alter power cable or plug and use extension cable.
Page 3
READ THIS MANUAL CAREFULLY BEFORE INSTALL AND KEEP IT FOR LATER REFERENCE. The Immersion UV-C generates UV-C radiation at a wavelength of 254 nm through the PHILIPS T5 UV lamp. The Immersion UV-C ensures clean, fresh and clear pond water in an efficient and environmentally-friendly manner.
• Do not use the unit if any of the components are damaged. This particularly applies to the quartz sleeve / UV lamp. If there is any damage, please disconnect the power supply immediately. • To ensure the high efficiency with best water quality, please check quartz sleeve regularly (Every 3 months.
INSTALLATION 1. Mount or place the Immersion UV-C at the desired location in the water. Please refer to the APPLICATIONS (p.2). 2. It is suggested to place the ballast in an area where is protected from splashing, flooding or dripping of water.
• Do not operate the unit with damaged plug or power cable. • In case the Immersion UV-C and / or its ballast are installed above an electric wall outlet, care must be taken that the power cable has a hanging loop below the power connection point (drip loop).