Page 1
PREFIXES DENOTE REFLECTORS, LAMP EMITTER AND BODY COLOUR REFERENCES BAHAMA XL HEATERS ARE DESIGNED AND MANUFACTURED FOR OUTDOOR USE. THEY CAN BE USED INDOORS BUT SHOULD BE USED IN CONJUNCTION WITH SUITABLE ENERGY SAVING CONTROLLERS TO COMPLY WITH EU 2015/118...
Page 2
C AU T I O N When using Tansun electrical heaters, basic precautions should always be followed to reduce the risk of fire, electric shock, and injury to persons, including the following: Read all instructions before using this heater. Before using this appliance: •...
Page 3
Do not use an extension cord with this product because the extension cord • may overheat and cause a risk of fire. Keep the mains supply cord away from the body of the heater which will get • hot during use. Arrange the mains supply cord so it cannot be tripped over or damaged.
I N S TAL L AT I O N The Bahama XL heater is fitted with 2m of supply cord therefore it is unnecessary to open the terminal box in order to carry out normal installation of this product and should not be interfered with.
Fig. B M AI N T E N AN C E In the event of heater failure, or for spare parts or advice, please contact Tansun Limited in the first instance. Disconnect from the mains before commencing any maintenance procedure including cleaning.
Page 6
R E P L AC I N G T H E L AM P E M I T T E R C A U T I O N If you are in any doubt about following the procedure below, please contact us for technical assistance.
Page 7
7. Remove the two screws as highlighted on in Fig. H to take out the side reflector bracket and reflector assembly that allows access the lamp emitter holding clip. Repeat at opposite end of lamp emitter. Fig. H 8. Where the lamp emitter wires are fed through the gasket into the terminal box (Fig. H), gently pull the lamp emitter wires through the body of the heater so the wires exit the terminal box.