Sentera Controls DTP-L Mounting And Operating Instructions

Digital temperature pipe sensor

Advertisement

Quick Links

DTP-L
DIGITAL TEMPERATURE
PIPE SENSOR
Mounting and operating instructions

Advertisement

Table of Contents
loading
Need help?

Need help?

Do you have a question about the DTP-L and is the answer not in the manual?

Questions and answers

Subscribe to Our Youtube Channel

Summary of Contents for Sentera Controls DTP-L

  • Page 1 DTP-L DIGITAL TEMPERATURE PIPE SENSOR Mounting and operating instructions...
  • Page 2: Table Of Contents

    STANDARDS WIRING AND CONNECTIONS MOUNTING & OPERATING INSTRUCTIONS IN STEPS VERIFICATION OF INSTALLATION MODBUS REGISTER MAPS TRANSPORT AND STORAGE WARRANTY AND RESTRICTIONS MAINTENANCE MIW-DTP-L-EN-000 - 30 / 05 / 2023 2 - 70 www.sentera.eu back to the table of contents...
  • Page 3: Safety And Precautions

    In case there are any questions that are not answered, please contact your technical support or consult a professional. MIW-DTP-L-EN-000 - 30 / 05 / 2023 3 - 70 www.sentera.eu...
  • Page 4: Product Description

    SENSOR PRODUCT DESCRIPTION The DTP-L series are digital temperature water pipe sensors powered over Modbus with 3,3 VDC via an RJ12 connector. They are intended for mounting onto metal pipes and are compatible with various temperature control systems. Thanks to the copper contact plate, we can ensure fast response times and faster response time and a more accurate temperature measurement of the media within the pipe.
  • Page 5: Wiring And Connections

    Ground, supply voltage Pin 7 MOUNTING & OPERATING INSTRUCTIONS IN STEPS Before you start mounting the DTP-L, read carefully “Safety and Precautions”. Follow these steps: Remove the rubber cap of the unit and mount the unit onto the pipe outer surface via placing the thermal pad between the copper plate and the pipe.
  • Page 6 NO T E On a Modbus RTU network, two bus terminators (NBTs) need to be activated. CAUTION Do not expose to direct sunlight! MIW-DTP-L-EN-000 - 30 / 05 / 2023 6 - 70 www.sentera.eu back to the table of contents...
  • Page 7: Verification Of Installation

    In case of heavy pollution, clean with a non-aggressive product. In these circumstances the unit should be disconnected from the supply. Pay attention that no fluids enter the unit. Only reconnect it to the supply when it is completely dry. MIW-DTP-L-EN-000 - 30 / 05 / 2023 7 - 70 www.sentera.eu...

This manual is also suitable for:

0.540.100.300.206.3

Table of Contents