CAMDEN CX-WEC10K2 Installation Instructions

E l ec t r if i e d Lo ck s , R e l ay s a n d Time rs
CX-WEC10K2
Emergency Control Kit
INSTALLATION INSTRUCTIONS
THIS PACKAGE INCLUDES:
1- CM-AF540SO (CM-450R/12, CM-AF501SO combo)
1. DESCRIPTION
The CX-WEC10K2 Emergency Control Kit allows an individual to
push the "PRESS FOR EMERGENCY ASSISTANCE" button to signal
for help by illuminating the "Assistance Required" annunciator
on the outside and the "Assistance Requested" annunciator
on the inside of the location. At the same time activating the
sounders built into both annunciators.
The kit also includes signage that states in the event of an
emergency to press the button and an audible and visual
signal will activate. The CX-WEC10K2 kit comes with the inside
activation and annunciator built onto a double gang combo-
plate making installations quicker since one back box install is
needed rather that two single gang boxes.
Note: CX-WEC10K2 Emergency Call System is OBC Regulation
368/13, Section 3.8.3.12 compliant.
2. OPERATION AT A GLANCE
When the "PRESS FOR EMERGENCY ASSISTANCE" button on
the CM-AF540SO is pushed in it will change its normally open
contact to a closed contact and activate the outside light and
sounder (CM-AF141S0) to signal for help. The inside light
and sounder (CM-AF540SO) will also be activated giving the
individual inside confirmation that the action has taken place.
Once the emergency has been attended to the red mushroom
button on the CM-AF540SO can be pulled out to silence and
reset the system.
Power
Both the CM-AF540SO and the CM-AF141SO can be powered
with either 12/24 VAC/VDC.
Note: When the CX-WEC10K2 is integrated with a Camden
Restroom Control Kit, VDC power must be used to prevent
the door strike from buzzing.
Wiring the CX-WEC10K2 Emergency Control Kit
The inside and outside annunciators are wired in parallel
to make them work at the same time when triggered.
Take one of the black wires from the CM-AF540SO and one
of the grey wires from the CM-AF141SO and tie them to the
power supplies VDC ground (-).
1- CM-AF141SO 1- CM-SE21A
Next, take the remaining wires (black and grey) from these
devices and wire it to the red mushrooms buttons normally
open contact marked as terminal "3".
Lastly, wire the terminal marked as "4" to the positive (+)
terminal of the VDC power supply.
Note: Some Door Operators provide excessive voltage levels
above their posted values. Always measure voltages provided
on both the VDC & VAC scales first before applying power to
any part of the Emergency Control Kit.
3. INSTALLATION
CM-AF540SO
Supplied with a stainless steel
faceplate that can be easily
mounted to a double gang
electrical box.
Volume Adjust
Turn the volume adjust
clockwise to increase the
volume and counter
clockwise to decrease the
volume. Turn the volume
adjust all the way counter
clockwise to turn the
sounder completely off.
P R
E S
E M
S F
E R
O R
A S
G E
S I S
N C
T A
Y
N C
E
Volume
Adjust
1
3
4
2
Page 1 of 4