Advertisement
Fitting Instructions
Please read these instructions carefully and check the
contents of the pack against the table below before
attempting to assemble and install this product. Please
ensure the correct wall plugs are used to suit your wall
type, if unsure consult your local DIY store.
Contents
Pole Length
A Pole
B Bracket
C Finial
D Rings
E Joiner
*Note: The 3.0m pole is available in both 1 and 2 pieces
DO NOT over reach. Always move the step ladder so that you are in a safe working position.
Take care when using power tools, use of a Residual Current Device (RCD) is recommended.
Always use eye protection when drilling. Beware of hidden pipe runs and cables.
No liability will be accepted for damage or injury caused by incorrectly installed or assembled product.
PLEASE KEEP OUT OF THE REACH OF YOUNG CHILDREN. SMALL PARTS - CHOKING HAZARD.
PLEASE KEEP THESE INSTRUCTIONS AND THE BATCH CODE ON THE PACKAGING FOR FUTURE
Elements Pole Kit
C
B
D
B
C
A
1.2m
1
2
2
12
-
Safety Recommendation
Always use a step ladder when working at height.
DO NOT hold or lean on the pole to support your weight.
We recommend you use two people for installation of a larger poles.
REFERENCE IN CASE OF ANY QUERIES.
Should any component be missing, please call the
3
2
1
Customer Care Department on 0330 005 2233.
Tools required: Pencil, measure, spirit level, drill,
screwdriver, hacksaw and file (if cutting down).
B
E
B
D
C
1.5m
1.8m
1
1
2
2
2
2
16
18
-
-
2
3
B
A
C
2.4m
3.0m*
3.0m*
2
1
3
3
2
2
24
30
1
0
100
3.6m
2
2
3
3
2
2
30
36
1
1
7676L--02
Advertisement
Table of Contents
Subscribe to Our Youtube Channel
Summary of Contents for Integra Elements Pole Kit
- Page 1 Elements Pole Kit Fitting Instructions Please read these instructions carefully and check the Should any component be missing, please call the contents of the pack against the table below before Customer Care Department on 0330 005 2233. attempting to assemble and install this product. Please...
- Page 2 17.5cm Installing the brackets Ceiling fixing the bracket (part sold separately) 1. Mark a light horizontal line 10cm to 20cm above the 15cm window to represent where your pole is going to sit. On 1. The bracket can be adjusted to 3 positions by your line, mark the end bracket positions 10cm from unscrewing the inner screw completely and 15cm...
- Page 3 470mm 282mm Preparing the pole (optional) 705mm 705mm Pole length = D1 + D2 + D1 470mm 282mm 1. Calculate the length of the pole. (fig. 8) 3. Ensure that the grub screw on the brackets are 2. Mark the cut line on the pole. Use masking tape if loosened and place the pole(s) in the brackets.
- Page 4 Installing the pole with eyelet or tab curtain 1. Ensure that the grub screw on the brackets are loosened and place the pole(s) in the brackets. (fig. 2. Lift one end of the pole and slide the eyelet/tab onto the pole ensuring that the last eyelet/tab is placed in between the bracket and the end of the pole.
Need help?
Do you have a question about the Elements Pole Kit and is the answer not in the manual?
Questions and answers