Do you have a question about the iGO CAM 445 and is the answer not in the manual?
Questions and answers
geoff
February 8, 2025
can't find the hardwire kit in the package.. or do you just cut off the 12 plug
1 comments:
Mr. Anderson
February 11, 2025
The Uniden iGO CAM 445 supports an optional hardwiring kit (HWK-3) for parking mode, but it is not stated that it comes included. There is no mention of cutting off the 12V plug.
Important Safety Instructions Uniden does not represent this product to be waterproof. Do not expose this product to Rain or Moisture. NOTE This product is intended for use in a motor vehicle. Don’t install the device where it will block the driver’s view of the road (including the mirrors!) or the deployment of the airbag.
Operation ................9 Micro SD Card ....................... 9 Power On ......................10 Power Off ......................10 Recording ......................11 Using the App ....................12 Device Settings ....................16 Troubleshooting ....................18 Specification .......................19 Warranty ................20 UNIDEN iGO CAM 445 Vehicle Recorder...
Installation Kits • Owner’s Manual • If any item is missing or damaged, contact your place of purchase immediately. Never use damaged products! • Need help? Get answers at our website: www.uniden.com.au for Australian model. UNIDEN iGO CAM 445 Vehicle Recorder...
Page 7
Press and hold 3 seconds turn on/off WiFi. Press and hold 8 seconds to format SD card and rest to factory reset. RED Blinking: Recording normal video. YELLOW Blinking: Recording locked video. Display 0.96 inch UNIDEN iGO CAM 445 Vehicle Recorder...
6. Adjust the viewing angle of the camera by rotating the body of the camera. We recommend the camera should point slightly downwards ~10° below eye level. Do not install the product in a location where it can obstruct the driver’s field of vision. NOTE UNIDEN iGO CAM 445 Vehicle Recorder...
It is advisable to get a car electrician to professionally install the hardwiring kit. Before installing the HWK-3, please ensure there is no SD Card installed on the camera unit. Only install the SD card once the HWK-3 is finish installing. NOTE UNIDEN iGO CAM 445 Vehicle Recorder...
It is important to format the micro SD card before using it, so as to avoid any damage to the files created on iGOCAM 445 Uniden only recommends using good quality MLC/SLC Endurance micro SD cards for dash cam recording. Please check with SD card manufacturer to ensure that the SD card used is rated for Dash Cam recording.
For the first time use, it is advisable to format the SD Card. Press and hold the WiFi (Smart One Touch) button for 8 seconds to format the SD Card. NOTE UNIDEN iGO CAM 445 Vehicle Recorder...
While recording, if you want to protect the current recordings, then SHORT PRESS the ONCE. Those recordings have been Smart One Touch button locked and will not be overwritten by normal video recordings. This also applies when the G-Sensor registers an impact while recording. UNIDEN iGO CAM 445 Vehicle Recorder...
Play Store for Android devices. Go to your mobile phone WiFi setting and connect to the camera’s access point. The SSID usually starts with UNIDEN-iGOCAM445 and the default password is 12345678. Go to the App and tap the camera.
Page 14
Downloaded Video Tap the Downloaded Video tab to view or playback downloaded photos or videos even when then the camera is not connected. About Tap to view App information or clear App cache data. UNIDEN iGO CAM 445 Vehicle Recorder...
Page 15
Live View Back Device Settings SD Card Full Screen Mode File Recording Timer Recording Snapshot Resolution Recording Switch File Sound recording Switch Mode Resolution settings Camera View Switch UNIDEN iGO CAM 445 Vehicle Recorder...
Page 16
Indicates the selected recording resolution. Full Mode Tap to view live video preview in full screen mode. Device Settings Modify camera settings. You can change WiFi SSID and password in the Camera Settings using the App. NOTE UNIDEN iGO CAM 445 Vehicle Recorder...
Opt to have the date and time displayed on the recordings. Record Audio Use this setting to enable or disable audio recording. Volume Adjust the camera volume level. OFF/Low/Middle/ High. Fatigue Driving OFF/1H/2H/4H Reminder Model Show Model name Logo Show Uniden Logo UNIDEN iGO CAM 445 Vehicle Recorder...
Page 18
Default Setting Factory default setting. Factory Default Resets the device to factory settings. Note that Settings restoring defaults will not erase data on the SD card. Device Information Display the device firmware version. UNIDEN iGO CAM 445 Vehicle Recorder...
2.4GHz (up to 10m line of sight) Storage microSD (up to 128GB), Class 10/U1 and above Power Input 5V 1.5A Battery Built-in Super Capacitor Operating Temperature -10°C ~ 60°C Storage Temperature -20°C ~ 70°C Working Humidity 10 ~ 80% UNIDEN iGO CAM 445 Vehicle Recorder...
IMPORTANT: Satisfactory evidence of the original purchase is required for warranty service Please refer to our Uniden website for any details or warranty durations offered in addition to those contained below. Warrantor: The warrantor is Uniden Australia Pty Limited ABN 58 001 865 498 (“Uniden Aust”).
Page 22
Product, together with satisfactory evidence of your original purchase (such as a legible copy of the sales docket) to Uniden. Please refer to the Uniden website for address details. You should contact Uniden regarding any compensation that may be payable for your expenses incurred in making a warranty claim.
Need help?
Do you have a question about the iGO CAM 445 and is the answer not in the manual?
Questions and answers
can't find the hardwire kit in the package.. or do you just cut off the 12 plug
The Uniden iGO CAM 445 supports an optional hardwiring kit (HWK-3) for parking mode, but it is not stated that it comes included. There is no mention of cutting off the 12V plug.
This answer is automatically generated