Lumascape rECHO-6 Install Notes

INSTALL NOTES: rECHO-6 & rECHO-8 RECESSED WALL BRACKETS
We have developed this series of field installation guidelines to assist you in correctly installing fixtures and transformers, ensuring
customer satisfaction and trouble-free service. If you have any questions, please call your local agent before proceeding. Follow all
NEC guidelines and local electrical codes. For more information, visit: lumascape.com
TYPICAL INSTALLATION:
Remove O-ring before
installation
Align prongs with the
11/32" holes when installing
ARCHITECTURAL & FACADE LIGHTING |
Install bracket
with prongs inside
mounting surface.
lumascape.com
Installation Guidelines:
The POBRKT and MOBRKT are to be used in conjunction with the
rEcho-6 and rEcho-8 luminaires. All components are utilized except
the conduit to mount in the vertical or hortizonal position. Utilizing the
POBRKT or MOBRKT requires an installation that is protected from
weather. The POBRKT should not be installed in drywall or sheetrock.
Start by using the template on the back of this page. Use a 11/32" drill
bit to drill pilot holes and complete by coring with a core drill (1.75" for
POBRKT and 2.25" for MOBRKT).
Install the bracket into the hole with the four-surface compatible
countersunk screws with the side prongs oriented towards the two 11/32"
pilot holes.
Install the faceplate with POBRKT/MOBRKT module installed. Remove the
outermost O-ring from the faceplate of the POBRKT. Before installing into
surface-mounted bracket, leave additional slack in wire in order to easily
remove the luminaire from the bracket.
CAUTION: The brackets and luminaires should always be checked before, during,
and monthly after installation to ensure all fasteners are tight. All set screws,
box covers, hardware and luminaire as a whole are at risk of falling if not properly
secured and may cause personal injury or damage to property, or cause a fire.
All wiring should be properly weatherproofed. This mount is intended only for
low-voltage luminaires. Abide by all local building codes when installing and
placing the luminaire mount.
See back page for mounting template.
IN0003US-240202
1